Pioneer DEH-5000UB 03Audio Adjustments, Using subwoofer output, Using the high pass filter

Section

03Audio Adjustments

3Use MULTI-CONTROL to select the de- sired setting.

Turn to change the setting.

LOW (low)—MID (mid)—HIGH (high)—OFF

(off)

# You can also perform the same operations by pushing MULTI-CONTROL up or down.

Using subwoofer output

4Turn MULTI-CONTROL to adjust the se- lected segement.

Cut off frequency

50HZ—63HZ—80HZ—100HZ—125HZ Level

+6 to –24 is displayed as the level is increased

or decreased.

# You can also perform the same operations by pushing MULTI-CONTROL up or down.

This unit is equipped with a subwoofer output which can be turned on or off.

Also, phase can be selected between normal and reverse.

1Use MULTI-CONTROL to select

SW SETTING 1.

2Press MULTI-CONTROL to display the setting mode.

3Use MULTI-CONTROL to select the de- sired setting.

Turn to change the setting.

NORMAL (normal phase)—REV (reverse

phase)—OFF (subwoofer off)

# You can also perform the same operations by pushing MULTI-CONTROL up or down.

Adjusting subwoofer settings

When the subwoofer output is on, you can ad- just the cut-off frequency and the output level of the subwoofer.

!When the subwoofer output is on, you can select SW SETTING 2.

1Use MULTI-CONTROL to select

SW SETTING 2.

2Press MULTI-CONTROL to display the setting mode.

3Press MULTI-CONTROL to select the seg- ment you wish to set.

Press MULTI-CONTROL repeatedly to switch the segment in the following order:

Cut off frequency—Level

Using the high pass filter

When you do not want low sounds from the subwoofer output frequency range to play from the front or rear speakers, turn on the HPF (high pass filter). Only frequencies higher than those in the selected range are output from the front or rear speakers.

1Use MULTI-CONTROL to select

HIGH PASS FILTER.

2Press MULTI-CONTROL to display the setting mode.

3Use MULTI-CONTROL to select the de- sired setting.

Turn to change the setting.

OFF—50HZ—63HZ—80HZ—100HZ—125HZ

# You can also perform the same operations by pushing MULTI-CONTROL up or down.

Boosting the bass

Bass boost function boosts the bass level of sound.

1Use MULTI-CONTROL to select

BASS BOOST.

2Press MULTI-CONTROL to display the setting mode.

3Turn MULTI-CONTROL to adjust the level.

0to +6 is displayed as the level is increased or

decreased.

# You can also perform the same operations by pushing MULTI-CONTROL up or down.

22 En