| Section |
Initial Settings | 04 |
|
|
3Turn
Turning
play.
# You can also perform the same operations by pushing
Note
The tuning step remains at 50 kHz during manual tuning.
Switching Auto PI Seek
The unit can automatically search for a differ- ent station with the same programming, even during preset recall.
1Use
2Press
seek on.
# To turn Auto PI seek off, press
Switching the auxiliary setting
PREOUT:REAR) or subwoofer
(REAR SP :SUB W/PREOUT:SUB W) connec- tion. If you switch the rear output setting to REAR SP :SUB W, you can connect a rear speaker lead directly to a subwoofer without using an auxiliary amp.
Initially, the unit is set for rear
1Use
SW CONTROL.
2Press
setting mode.
# Press BACK to return to the previous display.
3Press
Press
REAR SP (rear speaker
English
It is possible to use auxiliary equipment with this unit. Activate the auxiliary setting when using auxiliary equipment connected to this unit.
1Use
2Press
# To turn AUX off, press
Setting the rear output and subwoofer controller
This unit’s rear output (rear speaker leads out- put and RCA rear output) can be used for full- range speaker (REAR SP :FULL/
4Use
Turn to change the setting.
When REAR SP (rear speaker setting) is se- lected.
REAR SP :SUB W (subwoofer)— REAR SP :FULL
When PREOUT (RCA output setting) is se- lected.
PREOUT:SUB W (subwoofer)—
PREOUT:REAR
# When no subwoofer is connected to the rear
output, select REAR SP :FULL.
# When a subwoofer is connected to the rear output, set for subwoofer REAR SP :SUB W.
En 25