JVC RX-730RBK Adjusting the Volume, Selecting the Front Speakers, English, On the front panel

English

SOURCE SELECT

VIDEO 1	VIDEO 2	VCR
TV SOUND	FM	AM
TAPE	CD	PHONO

Remote: Outside

From the remote control:

Press one of the buttons on the SOURCE SELECT section.

VIDEO1	Play back a video source on the video component connected to the VIDEO1 jacks.
VIDEO2	Play back a video source on the video component connected to the VIDEO2 jacks.
VCR	Play back a video source on the video component connected to the VCR jacks.
TV SOUND	Listen to TV sounds.
FM*	Listen to FM broadcasts.
AM*	Listen to AM (MW/LW) broadcasts.
TAPE*	Listen to a cassette tape.
CD*	Listen to a CD.
PHONO*	Listen to a record.

Note:

When you press one of the buttons on the SOURCE SELECT section marked above with an asterisk (*), the receiver automatically turns on.

Adjusting the Volume

When you change the volume level, the volume level is shown on the display.

	MASTER VOLUME
–		+	On the front panel:
			To increase the volume, turn MASTER VOLUME clockwise.
			To decrease the volume, turn MASTER VOLUME counterclockwise.
			When you turn MASTER VOLUME rapidly, the volume level also changes rapidly.
			When you turn MASTER VOLUME slowly, the volume level also changes slowly.
	Front panel
			From the remote control:

VOLUME

Remote: Outside

To increase the volume, press VOLUME +.

To decrease the volume, press VOLUME –.

CAUTION:

Always set the volume level to the minimum before starting any source. If the volume level is left turned up, the sudden blast of sound energy can permanently damage your hearing and/ or ruin your speakers.

Selecting the Front Speakers

		On the front panel only:
SPEAKERS		When you have connected two pairs of the front speakers, you can select which to use. Pressing SPEAKERS
		1 or SPEAKERS 2 to set it in the _ON position activates the respective pair of the speakers.
1	2
		To use the speakers connected to the FRONT SPEAKERS 1 terminals, press SPEAKERS 1 to set it in
_ON ÑOFF		the _ON position, and press SPEAKERS 2 to set it in the ÑOFF position.
		To use the speakers connected to the FRONT SPEAKERS 2 terminals, press SPEAKERS 2 to set it in
		the _ON position, and press SPEAKERS 1 to set it in the ÑOFF position.
		To use both pairs of the speakers, press both SPEAKERS 1 and 2 to set them in the _ON position.
Front panel		To use neither pair of the speakers, press both SPEAKERS 1 and 2 to set them in the ÑOFF position.

Note:

When only one pair of the speakers is connected to either the FRONT SPEAKERS 1 or 2 terminals, do not press both SPEAKERS 1 and 2 to set them in the _ON position. If you do, no sound comes out of the front speakers.

Page 13