English
Erasing stored signals
LEARN CANCEL
Remote: Inside
LEARN CANCEL
Remote: Inside
EXT.1
TV VCR EXT.2
CD TAPE
Remote: Inside
LEARN CANCEL
Remote: Inside
After erasing stored signals, preset signals are resumed and you can operate JVC’s components again.
1Open the outside panel of the remote control.
2Press LEARN so that the SEND/LEARN indicator lights up (green).
Lights
SEND/LEARN ERROR
3Press CANCEL.
Both the SEND/LEARN and ERROR indicators light up.
SEND/LEARNERROR
Lights | Lights |
SEND/LEARN ERROR
4Press and hold the one of the buttons on the remote mode section until both the SEND/LEARN and ERROR indicators start flashing.
All the signals assigned in the selected remote mode are erased at the same time. You cannot erase a signal assigned to a particular button only.
|
|
| SEND/LEARN | ERROR | |||||
Flashes |
|
|
|
|
|
|
|
| Flashes |
| SEND/LEARN |
|
|
| |||||
|
|
| ERROR | ||||||
Lights 
SEND/LEARN ERROR
Note:
If the ERROR indicator remains lit, no signals are assigned to the buttons in the selected remote mode. In this case, press CANCEL to turn off the ERROR indicator.
5Press LEARN again to finish the erasure. The SEND/LEARN indicator goes off.
SEND/LEARN ERROR
Page 49
