JVC RX-730RBK manual Using the Remote Control, Tuner, Sound control section Amplifier, English

Changes the center speaker output level for the surround modes. Changes the left/right rear speaker output level for surround modes.

Changes the delay time for surround modes.

Checks the speaker output level for surround modes.

Using the Remote Control

Using this remote control, you can operate audio/video components of not only JVC’s but also the other manufacturers’. To operate the other manufacturers’ components, see page 47.

Using the Remote Control for Operating JVC Audio/Video Components

IMPORTANT:

To operate JVC audio components using this remote control:

•You need to connect JVC audio components through the COMPU LINK-3 (SYNCHRO) jacks (see page 41) in addition to the connections using cables with RCA pin plugs (see page 9).

•Aim the remote control directly at the remote sensor on the receiver.

•Select a source with the buttons on the SOURCE SELECT section (outside panel) of the remote control, or press the buttons on the remote mode section (inside panel) of the remote control. If you select a source on the front panel or using the menu function, the remote control will not operate that source.

Tuner

FM	AM	After pressing FM or AM (on the SOURCE SELECT section of the outside panel) or TUNER (on the remote
		mode section of the inside panel), you can perform the following operations on the built-in tuner:

English

Remote: Outside

TUNER

	DELAY	– CENTER +
1	2	3	4
	TEST	– REAR	+
5	6	7/P	8

FM

MODE/MUTE

9 10 0 +10

PRESET TV

CHANNELVOLUME

PTY SELECT		PTY SELECT
–	PTY SEARCH	+	TV/VIDEO
	DISPLAY MODE		TAPE

Remote: Inside

1 – 10, +10	Selects the preset channels directly.
	For preset channel number 5, press 5.
	For preset channel number 15, press +10, then 5.
	For preset channel number 20, press +10, then 10.
	For preset channel number 30, press +10, +10, then 10.
FM MODE/MUTE	Changes the FM reception mode.
PRESET CHANNEL +/–	Changes the preset channels.
RDS operating buttons
PTY SEARCH	Starts and ends searching a broadcast using the RDS.
PTY SELECT +/–	Selects a program type.
DISPLAY MODE	Changes the RDS display mode.

Note:

To activate the remote control for tuner operations, you can use the FM button or the AM button on the SOURCE SELECT section or the TUNER button on the remote mode section. If you press the button on the remote mode section, you can operate the tuner using the remote control, but the playing source will not be changed to “FM” or “AM.”

Sound control section (Amplifier)

SURROUND

MODE

SEA

MODE

Remote: Outside

SOUND

CONTROL

Remote: Inside

DELAY – CENTER +

You can always perform the following operations:

SURROUND MODE	Changes the surround modes.
SEA MODE	Changes the SEA modes.

After pressing SOUND CONTROL on the remote mode section of the inside panel, you can perform the following operations:

CENTER +/– REAR +/–

DELAY TEST

1	2	3					4	Note:
				– REAR			+
	TEST							After adjusting sounds, press the corresponding button on the remote mode section to operate your target
5	6		7/P				8
								source by using 10 keys; otherwise, 10 keys cannot be used for operating your target source.
			FM
		MODE/MUTE
9	10	0					+10
	PRESET					TV
	CHANNEL				VOLUME

PTY SELECT		PTY SELECT
–	PTY SEARCH	+	TV/VIDEO
	DISPLAY MODE		TAPE

Remote: Inside

Page 42