LEARN CANCEL
Remote: Inside
After several seconds, the SEND/LEARN indicator goes off and lights up again. This means that the storing is successfully finished.
SEND/LEARN ERROR
Lights
SEND/LEARN ERROR
Notes:
•If the SEND/LEARN indicator stops flashing before you press the button on the target remote control, repeat from step 5 again.
•If the ERROR indicator lights red and does not go off, you have failed in storing the signal.
•If the ERROR indicator flashes, you have failed in storing the signal. Try again. However some signals do not match to this remote control even though this remote control can lean most infrared signals.
7Repeat steps 5 to 6 to store more signals in the same remote mode. Repeat steps 4 to 6 to store more signals in a different remote mode.
8Press LEARN to finish the storing procedure.
SEND/LEARN ERROR
Note:
The signals stored into this remote control from the target remote control deviates slightly from the original signals. Since some components will not accept these deviating signals, you may not be able to operate those components using this remote control even though the storing procedure has been successfully finished.
CAUTION:
When replacing the batteries, finish it without delay; otherwise, the stored signals are all erased.
English
Using stored signals
EXT.1
TV VCR EXT.2
CD TAPE
| DELAY | – CENTER + | |
1 | 2 | 3 | 4 |
| TEST | – REAR | + |
5 | 6 | 7/P | 8 |
FM
MODE/MUTE
9 10 0 +10
PRESET 
TV
CHANNELVOLUME
PTY SELECT |
| PTY SELECT |
|
– | PTY SEARCH | + | TV/VIDEO |
| DISPLAY MODE |
| TAPE |
|
|
|
When you want to use the stored signals, follow the procedure below.
1Open the outside panel of the remote control.
2Press one of the remote mode buttons.
3Press the desired button.
Note:
When you have stored signals into the TV and VCR buttons, simply pressing the button will send the stored signals. You do not have to press a remote mode button.
TV VCR
Remote: Outside
Remote: Inside
Page 48
