English
COMPU LINK Remote Control System
The COMPU LINK remote control system allows you to operate JVC audio components through the remote sensor on the receiver.
To use this remote control system, you need to connect JVC audio components through the COMPU LINK- 3 (SYNCHRO) jacks (see below) in addition to the connections using cables with RCA pin plugs (see page 9).
CD player
Cassette deck
COMPU LINK – 3
(SYNCHRO)
Turntable
Notes:
•If your audio component has two COMPU
•Refer also to the manuals supplied with your audio components.
This remote control system allows you to use four functions listed below.
7Remote Control through the Remote Sensor on the Receiver
You can control the connected audio components through the remote sensor on the receiver using this remote control. For details, see pages 42 and 43.
Note:
Aim the remote control directly at the remote sensor on the receiver.
7Automatic Source Selection
When you press the play (3) button on a connected component or on its own remote control, the receiver automatically turns on and changes the source to the component. On the other hand, if you select a new source on the receiver or the remote control, the selected component begins playing immediately.
In both cases, the previously selected source continues playing without sound for a few seconds.
7Automatic Power On/Off (Standby) (only possible with the COMPU
Both the CD player and cassette deck turn on and off (into standby mode) along with the receiver.
When you turn on the receiver, the CD player or cassette deck will turn on automatically, depending on which component has been previously selected.
When you turn off the receiver (into standby mode), both the CD player and cassette deck will turn off (into standby mode).
7Synchronized Recording
Synchronized recording means the cassette deck starts recording as soon as a CD or a record begins playing.
To use synchronized recording, follow these steps:
1Put a tape in the cassette deck, and a disc in the CD player (or a record on the turntable).
2Press the record (¦) button and the pause (8) button on the cassette deck at the same time. This puts the cassette deck into recording pause.
Note:
If you do not press the record (¦) button and pause (8) button at the same time, the synchronized recording feature will not operate.
3Press the play (3) button on the CD player or on the turntable.
The source changes on the receiver, and as soon as play starts, the cassette deck starts recording. When the play ends, the cassette deck enters recording pause, and stops about 4 seconds later.
Notes:
•During synchronized recording, the selected source cannot be changed.
•If your CD player is playing in program mode, a
•If the power of any component is shut off during synchronized recording, the COMPU LINK remote control system may not operate properly. In this case, you must start again from the beginning.
Page 41
