JVC RX-730RBK manual Erasing a program, Repeat until you program up to 16 steps, Press Cancel

LEARN CANCEL

Remote: Inside

6Repeat step 5 until you program up to 16 steps.

Notes:

•If the ERROR indicator flashes several times, you cannot program this step.

– 16 steps are already programed or this particular step is not programmable.

•You cannot program an operation performed by pressing two buttons at the same time — like pressing ¦and 3 at the same time to start recording.

•Do not program a TV operation step immediately after the step of turning on the TV. The TV operation may be ignored since the TV is not yet ready to accept the signal.

7Press LEARN again to finish the programing procedure. Both the SEND/LEARN and ERROR indicators go off.

SEND/LEARN ERROR

CAUTION:

When replacing the batteries, finish it without delay; otherwise, the stored signals are all erased.

English

Erasing a program

LEARN CANCEL

Remote: Inside

LEARN CANCEL

Remote: Inside

SEQUENTIAL PROGRAM KEY

ABC

Remote: Outside

LEARN CANCEL

Remote: Inside

1Open the outside panel of the remote control.

2Press LEARN so that the SEND/LEARN indicator lights up (green).

Lights

SEND/LEARN ERROR

3Press CANCEL.

Both the SEND/LEARN and ERROR indicators light up.

SEND/LEARNERROR

Lights Lights

SEND/LEARN ERROR

4Close the outside panel, and press and hold SEQUENTIAL PROGRAM KEY A, B, or C to which the program you want to erase has been assigned to, until both the SEND/LEARN and ERROR indicators start flashing.

	SEND/LEARN	ERROR
Flashes			Flashes
	SEND/LEARN
		ERROR

Lights

SEND/LEARN ERROR

Note:

If the ERROR indicator remains lit, no program is assigned to the SEQUENTIAL PROGRAM KEY. In this case, press CANCEL to turn off the ERROR indicator.

5Press LEARN again to finish the erasing procedure. The SEND/LEARN indicator goes off.

SEND/LEARN ERROR

Page 46