1. BASIC PLAY

1 Press the set OPEN button and lift the LCD screen.

2 Slide the DVD player’s POWER switch to the ON position, the DVD logo (start-up picture) will appear on the screen.

3 Press the OPEN button on the DVD player to open the disc door. Place a disc gently on the tray with the label side up and close the door by pushing it down. The DVD player starts to read the disc’s table of contents (this may take a few seconds).

NOTE 1: Load the disc with the label side facing up, when

playing a double-sided disc, load it with the desired

playing side face down.

NOTE 2: “NO DISC” will show in the display if the disc is upside

down or the disc is badly scratched or dirty, it will not play. Please clean it or change the disc before use.

Also you can buy a disc polisher to try to repair the scratched disc.

4 Some discs will start playing automatically, and others will display the Disc Contents Menu on

the screen. If the menu is shown, use the , ,

&

buttons to highlight your selection

and press the OK button to confirm.

 

 

5 Press the VOLUME + or VOLUME button to adjust the volume level.

6 Press the BRIGHTNESS and COLOR buttons to adjust the brightness and the color of the LCD screen.

7 To stop playback, press the STOP button.

8 To pause the playback, press the OK button on the remote or the PLAY/PAUSE button on the player. To resume playback, press the OK button on the remote or the PLAY/ PAUSE button on the player again.

NOTE 1: During play, pressing the STOP button once will show “PRE STOP ” in the display, If you press the STOP button the second time, the display will show

“STOP ”, and now your system is in the full STOP mode.

NOTE 2: Leaving the set in the stop mode for a longer time will drain the battery the same

as during normal play.

 

 

 

9 To skip to another track/chapter, press the NEXT

 

or PREVIOUS

button repeatedly

 

 

during playback.

 

 

 

10 To access the disc menu or title menu during DVD play, press the MENU or TITLE button on the remote control.

11 Remember to shut off the player by sliding the POWER switch to the OFF position when the movie finishes playing.

NOTE: This player has a screen saver which will display a bouncing DVD logo if no video is played for a while.

10

IB-PDV705-WM-E-010506

IB-PDV705-WM-E-010506.pmd11

4/3/2006, 9:24 AM

Page 11
Image 11
Lenoxx Electronics PDV-705 instruction manual Basic Play