TELEPHONE OPERATION
1.RECEIVING A CALL: When your telephone rings, pick it up and use like any basic telephone.
2.DIALING A CALL: Pick up the phone, wait for dial tone and dial the number desired.
3.ENDING A CALL: After you have finished a conversation, just hang up.
4.TO REDIAL LAST NUMBER: If you want to redial the last number quickly, get a new dial tone, press the Redial Button. To erase redial memory, lift the handset and dial any numbers.
5.FLASH BUTTON: The button is used to get a new dial tone, also this button is used to activate customer calling services available through your local phone company, such as call waiting. These service are provided by your phone company and cost extra.
6.MUTE BUTTON: Pressing the Mute Button prevents the other party from hearing your conversation WHILE THE BUTTON IS HELD DOWN.
WALL MOUNTING
The phone can be mounted on a wall phone plate.
1.Use the SHORT Straight Wall Cord. 2.Plug one end into the top of the phone. 3.Plug the other end into wall jack.
4.Route the cord into the channel as shown. 5.Put phone over wall plate, make sure both posts fit into slots on the back of phone. Then push down to
lock phone onto wall plate. NOTE: After your phone is mounted, listen for dial tone to confirm the connection is good.
REVERSIBLE HANDSET HOLDER - When the telephone is mounted on the wall, the Reversible Handset Holder must be adjusted so it will hold the Handset.
1.SLIDE OUT | 2.REVERSE | 3.REPLACE INTO PHONE |
HANDSET HOLDER
WALL MOUNTING WITHOUT A WALL JACK
FOLLOW THESE INSTRUCTIONS TO MOUNT THE PHONE ON THE WALL
WITHOUT A WALL JACK. | MOUNTING AREA |
1 . Drill 2 holes 3 15/16" (100mm) apart.
2 . Put a screw into each hole and leave 3/16" (5mm) of the head exposed.
3 . Connect the straight cord to the phone and jack.
4 . Put the keyhole slots over the screws and slide down to secure phone.
4
MOUNTING
ANCHOR SCREW
3 15/16”
(100 MM)
LEAVE 3/16” (5 MM)
SCREW EXPOSED
