LevelOne IPS-0008 user manual Error codes, Error code Description

Error codes

Error code Description

E01 Network link down

E02 Parameters checksum error

E03 Input voltage over threshold high (Volt)

E04 Input voltage over threshold low (Volt)

E05 Outlet A current over threshold (Amp)

E06 Outlet B current over threshold (Amp)

E07 Outlet C current over threshold (Amp)

E08 Outlet D current over threshold (Amp)

E09 Outlet E current over threshold (Amp)

E10 Outlet F current over threshold (Amp)

E11 Outlet G current over threshold (Amp)

E12 Outlet H current over threshold (Amp)

E13 Input source abnormal (for 110V model)

E14 Input source abnormal (for 220V model)

E15 Input current sensor value abnormal

E16 Input source phase incorrect (see note below)

Note: IPS-0008 detects the phase of the input source automatically. If the phase is opposite to that of the outlet phase, the outlet is turned off. The corresponding error code is displayed on the input power status indicator on the front panel with the error code and a message is displayed in a pop-window from your browser. The log is updated with information about this event. To prevent this condition from occur- ring, select the Control Group submenu under the IPS-0008 Configuration Menu and set the Input Phase Detection item to Disabled.

37