
System Configuration
Lexicon
Be sure the limiter is set to ON before exiting. Press DONE to exit and automatically set the limiter to the level you have selected.
Mute Level
This menu allows you to set the level of attenuation used whenever the
Power On Volume
This control in the Output Levels menu allows you to select the volume at which the
Zone 2 Power On Volume
This control in the Output Levels menu allows you to select the initial volume level for Zone 2. You can choose from a range of
Setting Listener Position
SETUP MENU
INPUT CONFIG
SPEAKER CONFIG
OUTPUT LEVELS
LISTENER POSITION
LOCK SETTINGS
Speaker Distance
The Listener Position menu is used for setting the surround and center delays and calibrating the Panorama effect.
| LISTENER POSITION | Adjust with ▲or ▼ | ||
|
|
|
|
|
SPEAKER DISTANCE | OFF | based on speaker distance | ||
A/V SYNC DLY | Off, 1 to 60ms (30ms in software Version 3) | |||
CALIBRATE PANORAMA | CAL NOISE, SPEAKER ANGLE, LISTENER POS | |||
L/R BALANCE | < > |
| ||
[ L_ _ _ _ _ _R ] | ||||
ZONE 2 BALANCE | < > |
| ||
[ L_ _ _ _ _ _R ] | ||||
|
|
|
|
|
The Speaker Distance control automatically sets the appropriate time delays for all of the loudspeakers in a system. Although this adjustment is not a substitute for proper speaker placement, it will help to ensure accurate signal arrival times from all channels at the listening position.
To set up Speaker Distance, you must physically measure the distance from the primary listening position to the front baffle of each individual speaker in your system. An easy and accurate way to accomplish this is to have a person sit in the primary listening position, holding the end of a measuring tape, while a second person extends the tape measure to the front baffle of each speaker in turn.
To enter these values, select SPEAKER DISTANCE in the Listener Position menu and press SELECT. Use ▲ and ▼ to highlight feet or meters and press SELECT. Press SELECT again to highlight NEAR- EST SPKR. Use ▲ and ▼ to enter the actual distance, then press DONE.
28