4090-001
Base Assembly Removal
1.Remove the front cover.
2.Remove the rear cover.
3.Disconnect the power supply connector at the system board.
4.Remove the two screws from the maintenance station assembly. Pull up the right side of the mid frame assembly and pull forward and remove the maintenance station assembly.
5.Remove the two screws securing the carrier frame to the base cover.
6.Slide the printer off the base cover.
Carrier Belt Removal
1.Remove the front cover.
2.Remove the carrier assembly.
3.Push the idler pulley to the right to release the tension on the belt and remove the belt.
Repair Information
