Lexmark Z82 manual Problem Cause & Solution

Problem	Cause & Solution
‘The scanner driver is	File setting required for I/O may not be proper.
not installed or an	Follow the instructions below :
operation environment	1) Start your windows.
is not set up properly.	2) Select Run from Start menu.
Re-install the scanner	3) Type sysedit, then click OK.
driver and try again’
	4) Select SYSTEM.INI file, and set the file as shown
message appears on the
	below.
screen
	•
	[386 Enh]
	•
	device = vecp.386
	•
	LPT1TurnAroundDelay = 50
	5) Restart your Windows.
‘Port is disabled.	I/O error occurs during scanning.
Check if the port is	Check the basic cable and the cable connection.
properly connected, or	If you still have the same message, open the
power is on. Then	system.ini file in the windows directory as described
restart your computer’
	above, and increase the time as much as required in
message appears on the
	increments of 10.
screen
‘Memory is not enough	There is not enough memory to save the scan
to save the scan image.	image. Exit all applications currently open, if not
Exit all applications if	required, in order to save memory.
not required, then try
again after memory
becomes available’
message appears on the
screen

9-12Troubleshooting 9-12