2
EXTERNAL EQUIPMENT SETUP
EXTERNAL EQUIPMENT SETUP
CONNECTING WITH A COMPONENT CABLE
■To avoid damaging any equipment, never plug in any power cord until you have finished connecting
all equipment.
■This section on EXTERNAL EQUIPMENT SETUP mainly uses diagrams for the 32/37/42/47LD4***
models.
■Image shown may differ from your TV.
This TV can receive Digital RF/Cable signals without an external digital set-top box. However, if you do
receive Digital signals from a digital set-top box or other digital external device, refer to the diagram as
shown below.
►HDMI Audio Supported format : Dolby Digital, PCM
DTS Audio format is not supported.

Component Input ports

To achieve better picture quality, connect a DVD player to the component input ports as shown below.
Signal Component HDMI
480i/576i O X
480p/576p O O
720p/1080i O O
1080p O
(50 Hz / 60 Hz only)
O
(24 Hz / 30 Hz /
50 Hz / 60 Hz)
Component ports on the TV Y PBPR
Video output ports
on DVD player
Y PBPR
Y B-Y R-Y
Y Cb Cr
Y Pb Pr
1Connect the video outputs (Y, PB, PR) of the
external equipment (digital set-top box, DVD,
etc.) to the COMPONENT IN VIDEO jacks on
the TV.
2Connect the audio output of the external equip-
ment (digital set-top box, DVD, etc.) to the
COMPONENT IN AUDIO jacks on the TV.
3Turn on the external equipment.
(Refer to the external equipment's manual for
operating instructions.)
4Select the Component input source using the
INPUT button on the remote control.
1
2
1
2
or
Downloaded From TV-Manual.com Manuals