T roubleshooting guide
Symptom | Possible Cause | Solution |
| • Water supply is not adequate in area | Check another tap in the house. |
| • Water supply taps are not completely | Fully open tap. |
| open. | Straighten hose(s). |
| • Water inlet hose(s) are kinked. | |
| • The filter of the inlet hose(s) are | Check the filter of the inlet hose(s). |
| clogged. |
|
| • Drain hose is kinked or clogged. | Clean and straighten the drain hose. |
| • The drain filter is clogged. | Clean the drain filter. |
| • Load is too small. | Add 1 or 2 similar items to help |
| • Load is out of balance. | balance the load. |
| • The appliance has an unbalance | Rearrange load to allow proper |
| detection and correction system. If | spinning |
| individual heavy articles are loaded (ex. |
|
| bath mat, both robe, etc.), this system |
|
| may stop spinning or even interrupt the |
|
| spin cycle altogether. |
|
•If the laundry is still too wet at the end of the cycle, add smaller articles of laundry to balance the load and repeat the spin cycle.
|
|
|
|
|
| • Is the door opend | Close the door completely. | ||
|
|
|
|
|
| ||||
|
|
|
|
|
| or not completely | ❋ If “ | ”is not released, call for service. | |
|
|
|
|
|
| closed? |
|
| |
|
|
|
|
|
|
|
| ||
|
|
|
|
|
|
| Unplug the power plug and call for service. | ||
|
|
|
|
|
|
|
|
| |
• Water overfills due to the faulty water | Close the water tap. | ||||||||
valve. | |||||||||
Unplug the power plug. | |||||||||
|
|
|
|
|
|
| |||
|
|
|
|
|
|
| Call for service. | ||
• Water level sensor has malfunctioned. | |||||||||
|
| ||||||||
|
|
| |||||||
• Over load in motor. |
|
| |||||||
|
|
| |||||||
• Check water supply. | Turn the tap on | ||||||||
|
|
|
|
|
|
| |||
|
|
|
|
|
|
| I f “ | ” is not released, unplug power | |
|
|
|
|
|
|
| plug and call service. | ||
31
