14 206-4213
Custom Master TV Setup
Channel
Auto Tuning (Channel Lineup)
Manual Tuning
Channel Edit
Channel Label
Picture
Picture Mode
Audio
Auto Volume
Clear Voice
Sound Mode
Balance
TV Speaker
Time
Auto Clock
Auto Off (Sleep Timer)
Option
Menu Language
Audio Language
Caption
Lock
Movie Rating
TV Rating – Children
TV Rating – General
Note: Some menu options vary between analog and digital channels and Aux inputs.

Clonable TV Setup Menu Features

This section describes how to create a customized Master TV Setup for cloning purposes when the TV is in
Pass-through Mode.
Note: Refer to FTG Mode information on pages 37 to 48 for details on entering FTG Mode and conguring/
editing the FTG Channel Map and FTG Installer Menu settings.
Note: Cloning requirements and procedures are described in detail on pages 28 to 36.

Cloning Methods

See also “Clonable TV Setup Menu Features” list below.
Using a USB Memory Device / .tlx File
• The .tlx le format clones Installer Menu settings and all TV
sources’ (analog, digital, AV1, HDMI, etc.) clonable setup menu
settings.
• Not intended for cloning an auto-tuned/edited Channel Map, as
the channel lineup is converted to a logical FTG Channel Map
when saved (Learned) from a TV to a .tlx le. If the .tlx le with
the FTG Channel Map is then used for Teaching purposes, all
Target TVs will be congured for FTG Mode via CPU.
Using a USB Memory Device / .tll File
The .tll le format clones the contents of the commercial controller
(PTC) memory, including an auto-tuned/edited Channel Map,
Installer Menu settings, and one TV source’s (analog, digital, or
Aux) clonable setup menu settings.
Using a Clone Programmer (TLL-1100A or LT2002)
Both the TLL-1100A and LT2002 clone the contents of the
commercial controller (PTC) memory, including an auto-tuned/
edited Channel Map, Installer Menu settings, and one TV source’s
(analog or Aux) clonable setup menu settings.

Before You Begin

• It is recommended that you disconnect all Aux
inputs if you intend to run Auto Tuning (Channel
Search). Under certain conditions, Auto Tuning
is disabled if there is an Aux input active.
• Determine which cloning tool—USB memory
device or clone programmer—is appropriate for
your application; several of the Master TV Setup
procedure steps are dependent on the cloning
tool to be used. See “Cloning Methods” at right
for further information.
• If you intend to use a USB memory device,
determine the type of le—either the new “.tlx”
le format or the legacy “.tll” le format—to use
for cloning purposes; several of the Master TV
Setup procedure steps are dependent on the
desired le type. See “Cloning Methods” at right
for further information.
• If the Automated Installation Routine Wizard
appears on the screen, exit the wizard before
beginning/continuing the Custom Master TV
Setup procedure.