LG Electronics 47WV30BS, 47WV30MS, 47WV30-BAAL, 47WV30BR, 47WV30-BAAM owner manual Picture ID

20REMOTE CONTROL

ENGLISH

Picture ID

Picture ID is used to change the settings of a specific set (display) using a single IR receiver for multi-vision. The set receiving the IR signal com- municates with another set via the RS232 connec- tor. Each set is identified by a Set ID. If you as- sign the Picture ID using the remote control, only displays with the same Picture ID and Set ID can be controlled remotely.

AUDIO

(RGB/DVI)	RS-232C OUT	RS-232C OUT	RS-232C OUT
	RS-232C IN	RS-232C IN	RS-232C IN

REMOTE

CONTROL IN

IR Receiver

Picture ID

Off

Close

2X2 Multi-Vision (Total Set ID: 4)

Set IDs are assigned as shown in the picture.

1 Press the ID On (Red) button on the remote con- trol.

BACK TILE EXIT

ID

ON OFF

2 If you press the left/right buttons or press the ON button repeatedly, the Picture ID cycles through OFF and 1 to 4.Assign the ID you want.

Picture ID

Off

Close

yyIf you assign the Set ID to each set with multi-vision, and then assign the Picture ID using the red button on the remote control, the key command is displayed for the set with the same Set ID and Picture ID. A set with different Set IDs and Picture IDs cannot be controlled by IR signals.

yyRefer to the Set ID on page 46 for assigning a Set ID.

yyThe maximum value of the Picture ID can be set in the Total Set ID menu.

yyPlease refer to the Installation Manual for more information on the assignment of a Total Set ID.

NOTE

yyFor example, if the Picture ID is assigned to 2, the upper right display (Set ID: 2) can be controlled by IR signals.

yyFor each set, you can change the settings for the PICTURE, AUDIO, TIME, OPTION, NETWORK and MY MEDIA menus or the hot keys on the remote control.

yyIf you press the ID OFF (Green) button, the Picture IDs for all sets are turned off. If you then press any button on the remote control, all sets will start working again.

yyThe Picture ID function may not work dur- ing MY MEDIA operating.