LG Electronics 60PN5300 Preventing Image burn or Burn-in on your TV, Screen, YyGenerated Sound

			IMPORTANT SAFETY INSTRUCTIONS	5
yyDot Defect		For USA and Canada
	The Plasma or LCD panel is a high technology
	product with resolution of two million to six million	FCC NOTICE
	pixels. In a very few cases, you could see fine dots
	on the screen while you’re viewing the TV. Those
	dots are deactivated pixels and do not affect the	This equipment has been tested and found to
	performance and reliability of the TV.	comply with the limits for a Class B digital device,
yyGenerated Sound		pursuant to Part 15 of the FCC Rules. These limits
	“Cracking” noise: A cracking noise that occurs	are designed to provide reasonable protection against
	when watching or turning off the TV is generated by	harmful interference in a residential installation. This
	plastic thermal contraction due to temperature and	equipment generates, uses and can radiate radio
	humidity. This noise is common for products where	frequency energy and, if not installed and used in
		accordance with the instructions, may cause harmful
	thermal deformation is required.
		interference to radio communications. However, there
	Electrical circuit humming/panel buzzing: A low level
		is no guarantee that interference will not occur in a
	noise is generated from a high-speed switching
		particular installation. If this equipment does cause
	circuit, which supplies a large amount of current
		harmful interference to radio or television reception,
	to operate a product. It varies depending on the
		which can be determined by turning the equipment
	product.
		off and on, the user is encouraged to try to correct
	This generated sound does not affect the
		the interference by one or more of the following
	performance and reliability of the product.
		measures:
yyTake care not to touch the ventilation openings.
			- Reorient or relocate the receiving antenna.
	When watching the TV for a long period, the
			- Increase the separation between the equipment
	ventilation openings may become hot. This does
			and the receiver.
	not affect the performance of the product or cause
			- Connect the equipment to an outlet on a circuit
	defects in the product.
			different from that to which the receiver is
			connected.
			- Consult the dealer or an experienced radio/TV
	Preventing “Image burn” or “Burn-in” on your TV		technician for help.
		This device complies with part 15 of the FCC Rules.
screen
		Operation is subject to the following two conditions:
		(1) this device may not cause harmful interference and
		(2) this device must accept any interference received,
		including interference that may cause undesired
		operation of the device.
		Any changes or modifications in construction of this
		device which are not expressly approved by the party
yyIf a fixed image displays on the TV screen for a long		responsible for compliance could void the user’s
		authority to operate the equipment.
	period of time, it will be imprinted and become a
	permanent disfigurement on the screen. This is
	“image burn” or “burn-in” and not covered by the		NOTE TO CABLE/TV INSTALLER
	warranty.
yyIf the aspect ratio of the TV is set to 4:3 for a		This reminder is provided to call the CATV system
	long period of time, image burn may occur on the
		installer’s attention to Article 820-40 of the National
	letterboxed area of the screen.
		Electric Code (U.S.A.). The code provides guidelines
yyAvoid displaying a fixed image on the TV screen for
		for proper grounding and, in particular, specifies that
	a long period of time (2 or more hours for LCD, 1	the cable ground shall be connected to the grounding
	or more hours for the Plasma TV) to prevent image	system of the building, as close to the point of the
	burn.	cable entry as practical.

ENGLISH