|
|
| ERROR CODES |
|
|
|
|
DISPLAY |
|
| EXPLANATION AND RECOMMENDED PROCEDURE |
F/H | No water detected entering machine or Pressure switch trip not detected. | ||
| If after 30 seconds the control does not detect water entering machine and then | ||
| valves will be turned off and the error code will be displayed. | ||
| Or |
|
|
| If the control has turned the water valves on and after 8 minutes the flow meter has | ||
| detected 10.5 gallons of water passing through it, but has not detected the pressure | ||
| switch trip, the valves will be turned off and the error code will flash. | ||
| Press PAUSE/CANCEL twice to clear the display. | ||
| Potential Causes | ||
| • If there is no water in the unit: | ||
|
| • | Make sure that both valves at the water source(s) are turned on all the way. |
|
| • | Check for plugged or kinked inlet hoses or plugged screens in the inlet valves |
|
| • | Verify inlet valve operation |
| • If there is water in the unit: | ||
|
| • | Verify Drain pump operation |
|
| • | Pressure Switch Hose is in good condition and properly connected to Tub and |
|
|
| Pressure switch |
| • Verify there is not a siphon problem | ||
| • Verify wire harness connections to; Inlet Valves, Pressure Switch, Drain Pump, | ||
|
| Flow Meter, and Central Control Unit (CCU) | |
| • Check all hoses for possible leaks | ||
| • Verify pressure switch operation | ||
| • Verify flow meter operation | ||
| • | Verify CCU operation | |
|
| ||
F/02 | Long Drain | ||
| If the drain time exceeds 8 minutes, the water valves are turned off and “F/02” is | ||
| flashed. | ||
| Press PAUSE/CANCEL twice to clear the display. | ||
| NOTE: After 4 minutes the “Sud” error will be displayed, then 4 minutes later | ||
| the F/02 error code will be displayed. | ||
| Potential Causes | ||
| • Check the drain hose and make sure it is not plugged or kinked | ||
| • Check the electrical connections at the pump and make sure the pump is | ||
|
| running. | |
| • Check the drain pump filter for foreign objects | ||
| • If the above does not correct the problem replace the pump | ||
F/05 | Water Temperature Sensor Error | ||
| If during the water heating step in the wash cycle, the water temperature sensor | ||
| (NTC) value is out of range, or the heating element circuit has failed, the “F/05” error | ||
| code will be displayed. | ||
| Potential Causes | ||
| • | Check the Water Temperature Sensor, Heating Element and Element Relay | |
| • Check connections to the Sensor, Heating Element and Relay | ||
|
|
|
|
6 - 4
