Whirlpool GHW9100L, GHW9200L manual Removing the Detergent Dispenser Assembly

REMOVING THE DETERGENT

DISPENSER ASSEMBLY

The Detergent Dispenser Assembly is located under the washer top. Begin by removing the washer top, console and front panel.

Separate the water inlet and window washer tube from the boot.

Pull the water inlet tube from the outlet connector of the detergent dispenser. (Fig. 4-16)

NOTE: When reinstalling the water inlet tube, wet the water inlet gasket on the detergent dis- penser with water only. Do not use any other lu- bricant. Align the locator nib on the water inlet tube with the indentation on the dispenser con- nector and slide the tube onto the detergent dis- penser assembly.

Remove the screw securing the front of the de- tergent dispenser assembly to the top front frame member. (Fig. 4-16)Screw

Water		Inlet	Fig. 4-16
	Tube

Disconnect the vent tube from the detergent dis- penser assembly. (Fig. 4-17)

Remove the screw securing the detergent dis- penser assembly to the top left frame member. (Fig. 4-17)Slide the assembly back slightly and lift the assembly out.

Screw Vent

Tube

Fig. 4-17

To remove the detergent dispenser motor assem- bly, disconnect the cam follower spring and lift the cam follower from the diverter cam and ro- tate the diverter cam clockwise to access the motor mounting screws.

Rotate Clockwise

Screws

(Under

Cam)

MotorFig. 4-18

4 - 5