INSTALLATION INSTRUCTIONS

Pedestal

Fig. 2-1

!WARNING

EXCESSIVE WEIGHT HAZARD

Use two or more people to move washer and dryer.

Failure to do so can result in back or other injury.

Before you start...

Important: If the washer is already installed, it must be uninstalled.

See installation instructions that came with the washer for tools required.

Uninstalling the Washer

1.Turn off the hot and cold water faucets.

2.Briefly start the wash cycle to release any pressure in the fill hoses.

3.Unplug the power supply cord.

2 - 6

4.Remove the “HOT” and “COLD” fill hoses from the back of the washer.

5.Disconnect the drain hose from the washer and drain any water in the hose into a bucket.

6.Pull the washer away from the wall so it can be tipped on its back.

7.Protect the floor with a large piece of cardboard cut from the pedestal carton. Lay the washer on its back so that the cardboard is under the entire lower back edge of the washer. (Fig. 2-2)Go to “Installing the Pedestal”.

Fig. 2-2

Page 14
Image 14
Whirlpool GHW9200L, GHW9100L manual Installation Instructions