JVC AV-28BK5ECB manual Installation, Connect aerial cables, Install batteries, Connect AC Cord

INSTALLATION

STEP 1 : Connect aerial cables

Insert an aerial plug tightly into the aerial socket on the back of the TV set.

✐For all aerial problems please consult your local dealer.

✐The connection to the peripheral AV equipment, refer to section “USING AV EQUIPMENT” on page 10, 11.

STEP 2 : Install batteries

1 Remove the battery cover by sliding it in direction of the arrow.

2 Install two "AAA/R03" 1.5 volt batteries so that the "+" and "-" marks on the batteries match the "+" and "-" marks inside the unit.

3 Close the battery cover.

✐Replace the batteries when the TV set is showing the following symptoms: Operation is unsteady or erratic, sometimes the TV does not work with the transmitter. Discharged batteries may leak and damage the unit. The normal life of batteries should be from nine to ten months.

Bij dit produkt zijn batterijen geleverd. Wanneer deze leeg zijn, moet u ze niet weggooien maar inleveren als KCA.

STEP 3 : Connect AC Cord

The TV set is prepared for a mains voltage AC220~240V, 50Hz. Connect the power cord of the TV set to a wall outlet. When the TV set is not to be used for an extended period of time, it is advisable to disconnect the power cord from the power outlet.

WARNING!

High voltages are used in the operation of this set. Refer service to qualified service personnel.

STEP 4: Turn Mains switch-on

This TV set provides a self-automatic tuning function called “Plug & Play”. The first time you switch on this TV set, it will automatically begin to search and store all available channels. To ensure that this feature works properly please follow the steps below before you switch on the TV set.

Please make sure that your aerial cable is connected to the aerial socket of the TV set before switching on.

Plug the Mains cable plug into a wall socket.

✐This TV set is prepared for a mains voltage of AC220~240V 50Hz.

1	You are now ready to switch on. Simply press the Mains
	ON/OFF switch on the front of the TV set.

A red power indicator will appear.

The first page of “ATS euro plus” appears.

If no picture appears but the power indicator is on, press the , P , P , P▲, P▼ or 0 - 9 button as the TV set is in the standby mode.

Select country and Language

2 Select the country using the ▲ ,▼ or ◀ or ▶ button. Press the P.MODE/OK button.

COUNTRY

A	B	CH	D	DK			E	F	GB
I	N	NL	P	S		SF		OTHERS
SELECT :
					OK			EXIT : MENU

The next page appears for selecting your display language.

Select the language identification letter by using the ▲ ,▼ or ◀
3 or ▶ button. Press the P.MODE/OK button.
		LANGUAGE
	D	DK	E		F		GB
	I	NL	P		S		SF
	SELECT :			OK		EXIT : MENU

After you have selected a language, all messages and information which subsequently appear on the screen will be in this language.

■The ATS euro plus system will start as follows: The tuning status and welcome messages will appear on the screen.

Thank you for purchasing your

JVC TV.

Now I am searching and storing all

programmes.		Please wait .
	POS.	2
	CH	C 5

4