INSTALLATION INFORMATION
INSTALLATION
REQUIREMENTS
Tools and Parts
Assemble the necessary tools and supplies before be- ginning the washer installation. The parts supplied are in the washer basket.
Tools needed for connecting the water inlet hoses
•Pliers (that open to 1 9/16 in.)
•Flashlight (optional)
Tools needed for installation
•Open end wrench 5/8 in. (17 mm) and ½ in. (13 mm)
•Level
•Wood block (2" x 4")
•Ruler or measuring tape
Parts supplied:
Beaded strap
Transport Bolt Hole
Plug (4)
Alternate Parts You May Need
If You Have | You Will Need to Buy |
Optional Pedestal
A pedestal may be purchased separately for this washer. This pedestal will add about 14 inches to the height of your unit for a total vertical height of approxi- mately 52 inches (132 cm).
Optional Pedestal
Location Requirements
Selecting the proper location for your washer improves performance and minimizes noise and possible washer “walk.”
Your washer can be installed under a custom counter, or in a basement, laundry room, closet, or recessed area. (See “Drain System.”)
Companion appliance location requirements should also be considered. Proper installation is your respon- sibility.
You will need
Laundry tub or standpipe taller than 96 in. (2.4 m)
Overhead sewer
Sump pump system (if not al- ready available)
Standard 20 gal. (76 L), 30 in. (76.2 cm) tall drain tub or util- ity sink and sump pump (avail- able from local plumbing sup- pliers)
• A water heater set to deliver 120°F (49°C) water |
to the washer. |
• A grounded electrical outlet located within 5 ft. |
(1.5 m) of where the power cord is attached to the |
back of the washer. (See “Electrical Require- |
ments.”) |
• Hot and cold water faucets located within 4 ft. |
(1.2 m) of the hot and cold water fill valves, and |
water pressure of |
• A level floor with a maximum slope of 1 in. |
(2.5 cm) under entire washer. Installing the washer |
Floor drain | Siphon break, Part Number |
| 285834; additional drain hose |
| Part Number 8318155; and |
| connector kit, Part Number |
| 285835 |
Drain hose too short | Drain hose extension kit, Part |
| Number 285863 |
Water faucets beyond | 2 longer water fill hoses: |
reach of fill hoses | 6 ft. (1.8 m) Part Number |
| 76314, 10 ft. (3.0 m) Part Num- |
| ber 350008 |
on carpeting is not recommended. |
• A sturdy and solid floor to support the washer with |
a total weight (water and load) of 400 lbs. (180 |
kg). |
Do not operate your washer in temperatures below 32°F (0°C). Some water can remain in the washer and can cause damage in low temperatures.
2 - 1
