TABLE OF CONTENTS 7
TABLE OF CONTENTS
2 IMPORTANT SAFETY INSTRUCTIONS
6 LICENSES
6OPEN SOURCE SOFTWARE NOTICE
7TABLE OF CONTENTS
8INSTALLATION PROCEDURE
8 ASSEMBLING AND PREPARING
8 Unpacking
11Optional Extras
(For LT560E, LS460E series)
12Parts and buttons
14 Setting up the TV
14- Attaching the stand
17- Mounting on a table
18- Mounting on a wall
20- Tidying cables
21- External Speaker Out
22 REMOTE CONTROL
FCC NOTICE
24GENERAL TROUBLESHOOTING
24CAUTION for using ezsign 2.0
25SPECIFICATIONS
27 EXTERNAL CONTROL DEVICE SETUP
27
27Type of connector;
28
29Communication Parameters
29Command reference list
30Transmission / Receiving protocol
NOTE
yyImage shown may differ from your TV. yyYour TV’s OSD (On Screen Display) may
differ slightly from that shown in this manual. yyThe available menus and options may differ
from the input source or product model that you are using.
yyNew features may be added to this TV in the future.
ENGLISH
This equipment has been tested and found to comply with the limits for a Class B digital device, pursuant to Part 15 of the FCC Rules. These limits are designed to provide reasonable protection against harmful interference in a residential installation. This equipment generates, uses and can radiate radio frequency energy and, if not installed and used in accordance with the instructions, may cause harmful interference to radio communications. However, there is no guarantee that interference will not occur in a particular installation. If this equipment does cause harmful interference to radio
or television reception, which can be determined by turning the equipment off and on, the user is encouraged to try to correct the interference by one or more of the following measures:
-Reorient or relocate the receiving antenna.
-Increase the separation between the equipment and the receiver.
-Connect the equipment to an outlet on a circuit different from that to which the receiver is connected.
-Consult the dealer or an experienced radio/TV technician for help.
This device complies with part 15 of the FCC Rules. Operation is subject to the following two conditions: (1) this device may not cause harmful interference and (2) this device must accept any interference received, including interference that may cause undesired operation of the device.
Any changes or modifications in construction of this device which are not expressly approved by the party responsible for compliance could void the user’s authority to operate the equipment.
