Connect the Power Cord to a wall outlet

ASSEMBLING AND PREPARING 7

WARNING

1Lift and tilt the Monitor set into its upright position on a table.

Leave a 10 cm (minimum) space from the wall for proper ventilation.

10 cm

When you adjust the angle, do not hold the buttom of the Monitor set frame as shown on the following illustration, as may injure your fingers.

ENGLISH

Do not touch or press the screen when adjusting the angle of the monitor.

2Connect the Power Cord to a wall outlet.

NOTE

Tilt from +15 to -5 degrees up or down to adjust the angle of the Monitor set to suit your view.

- 5

CAUTION

Disconnect the power cord first, and then move or install the Monitor set. Otherwise electric shock may occur.

Image 7

Contents

3D Monitor Contents Stand Base 3D Glasses Assembling and PreparingUnpacking Stand Body Parts and buttons Power Button Button See p.13Connection panel See p.10 Unlocked OSD LockedSuper Energy Hinge Body Stand Body Setting up the Monitor setAttaching the Stand Base Detaching the Stand Base and Body Press button on the front switch panel to turn Power on Connect the Power Cord to a wall outlet Mounting on a wall D2342P DVI-D connection Using the Monitor SETConnecting to a PC SUB connection Turned on, the Self Image Setting Function is Exit Customizing SettingsAccessing main menus Monitor set button Mnue settings Customizing settings Volume settingsOnly Hdmi mode 3D settingsOnly 3D modeAvailable picture settings are described in the following Reset Super Energy Saving settings Troubleshooting Troubleshooting When Using 3D Mode D2342P Specifications Indicator Preset Modes Resolution Symptoms Precautions to Take When Viewing 3D Images Proper Posture Proper posture for using the Monitor setPrecautions to take when viewing 3D images Adjust Model Serial