3–2

Installing Hardware Accessories

Adding Third–Party Boards to Expansion Slots

Loosen the two thumb screws on the hinged lid of the D4–470 to open the lid and expose the interior of the case. The compartment is compact but accessible. Remove the two screws that hold the upper card edge bracket in place and remove the bracket.

WARNING: To minimize the risk of electrical shock, personal injury, or equipment damage, always turn off the system power before opening the case of the D4–470 and before connecting peripheral devices to the D4–470.

As you will notice in the photo below, we removed the backplane circuit board from the D4–470 case to facilitate veiwing. Do not remove the backplane board to install expansion boards.

Four ISA and PCI Viewed as shown below, the PCI slots use the three white connectors indicated. The

Expansion Slots ISA slots use the black connectors also identified below. The third PCI connector from the top and upper ISA connector occupy the same slot position. This is the full length slot. It can be use as either a PCI or ISA slot but not both.

Page 23
Image 23
LG Electronics D4470 user manual Adding Third-Party Boards to Expansion Slots