LG Electronics DU-37LZ30 NOTE All cables shown are not included with the TV, VCR Setup, Cable Box

Installation

NOTE: All cables shown are not included with the TV

VCR Setup

-To avoid picture noise (interference), leave an adequate distance between the VCR and TV

-Typically a frozen still picture from a VCR. If the 4:3 picture format is used; the fixed images on the sides of the screen may remain visible on the screen.

Connection Option 1

Set VCR output switch to 3 or 4 and then tune

TV to the same channel number.

Connection Option 2

1.Connect the audio and video cables from the VCR's output jacks to the TV input jacks, as shown in the figure.

When connecting the TV to VCR, match the jack colors (Video = yellow, Audio Left = white, and Audio Right = red).

If you connect an S-VIDEO output from VCR to the S-VIDEO input, the picture quality is improved; compared to connecting a regular VCR to the Video input.

2.Insert a video tape into the VCR and press PLAY on the VCR. (Refer to the VCR owner’s manual.)

3.Select the input source with using the TV/VIDEO button on the remote control. (If connected to A/V INPUT 1, select Video 1 input source)

Do not connect to both Video and

S-Video at the same time.

	COMPONENT 2	DVD	MONITOR			DVI INPUT
			OUTPUT
		/DTV				(PC/DTV INPUT)
	COMPONENT 1	INPUT	A/V		S-
			INPUT1			Antenna 2
				(MONO)	Antenna1
R	L		R AUDIO	L	VIDEO
RGB INPUT
(PC/DTV INPUT)

AUDIO INPUT VIDEO INPUT

1

2

ANT IN

ANT OUT S-VIDEO OUT

OUTPUT		(R) AUDIO (L)	VIDEO
SWITCH			VCR
3	4	IN

Cable TV Setup

-After subscribing to a cable TV service from a local provider and installing a converter, you can watch cable TV programming. The TV cannot display TV programming unless a TV tuner device or cable TV converter box is connected to the TV.

-For further information regarding cable TV service, contact your local cable TV service provider(s).

Connection Option 1

1.Select 3 or 4 with channel switch on cable box.

2.Tune the TV channel to the same selected output channel on cable box.

3.Select channels at the cable box or with the cable box remote control.

Connection Option 2

1.Connect the audio and video cables from the Cable Box's output jacks to the TV input jacks, as shown in the figure.

When connecting the TV to a Cable Box, match the jack colors (Video = yellow, Audio Left = white, and Audio Right = red).

2.Select the input source with using the TV/VIDEO button on the remote control. (If connected to A/V INPUT 1, select Video 1 input source)

3.Select your desired channel with the remote control for cable box.

	COMPONENT 2	DVD	MONITOR			DVI INPUT
			OUTPUT
		/DTV				(PC/DTV INPUT)
	COMPONENT 1	INPUT	A/V		S-VIDEO
			INPUT1	(MONO)		Antenna 2
R	L		R AUDIO	L	VIDEO

AUDIO INPUT VIDEO INPUT

2 1

(R) AUDIO (L)	VIDEO
	OUTPUT
TV	SWITCH
	3	4
VCR		RF	Cable

Cable Box

12