Installing and Composition
Turning on the Projector
1.Connect power cord correctly.
2.Press the POWER button( 
) on the Control panel. (The light on the control panel will be turned on.)
●Use the SOURCE button on the control panel to select the input signal you want.
●When you press the POWER button( 
) on the control panel when you turn on the projector, the lights for all buttons on the control panel will be turned on.
Turning off the Projector
1.Press the POWER button( 
) on the Control panel.
2.Press the POWER button( 
) on the Control panel again to turn off the power.
●When you press the POWER button( 
) on the control panel when you turn off the projector, the lights for all the but- tons on the control panel will be turned off. When you press any button on the control panel when the projector is turned off, the light only on the POWER LED will be turned on. (When the Power cord is connected.)
Power off?
Please Press 
Key Again.
Focus and Position of the Screen Image
When an image appears on the screen, check if it is in focus and fits well to the screen.
Focus ring
●To adjust the focus of the image, rotate the focus ring which is the outer ring on the lens.
Selecting source mode
1. Press the SOURCE button.
Select
FRGB
OK
G
2. Each press of the F, G button changes the display as below.
RGB
Digital Video
Video
●When you connect the RGB to Component cable to the RGB IN (PC/DTV) terminal and select RGB input, you can receive the Component input.
●Digital video is the signal to receive and display the digital video signal through the HDMI jack.
14
