BACK COVER
EXPLOSION HAZARD
ELECTRICAL SHOCK HAZARD
Before you begin, either unplug the refrigerator or turn off power at the circuit breaker or fuse box.
Do not use flammable cleaners. Not following these instructions can cause death, explosion or fire.
The refrigerator, as well as the freezer, do their own
up of contaminants, therefore it is suggested that you clean both parts once a month; clean spilled liquids immediately.
REFRIGERATOR CLEANING
•Unplug your refrigerator.
•Pull out all of the removable parts (such as the vegetable and dairy doors).
•Use a clean sponge (or a soft rag) and use it with
lukewarm water mixed with detergent. Do not use
abrasive or concentrated cleaners.
•Hand wash it, and dry it thoroughly.
•Plug the refrigerator back in.
OUTSIDE
Wax the outside in order to create better protection. Make
sure you use a product specifically design to be used
for
For
it with water and detergent. Do not use concentrated or abrasive products.
NOTE: Avoid the usage of chemical products that contain phosphates or bleach.
INSIDE (Allow freezer to slightly warm up a small degree to prevent cloth from sticking)
In order to eliminate bad odors, clean the inside of
the refrigerator with a mixture of baking powder and lukewarm water (one teaspoon of baking powder per cup of water). Ensure that the powder dissolves thoroughly, in order to prevent any sort of damage.
DOOR LINING AND GASKETS
Use only a mild detergent (such as dish soap).
PLASTIC PARTS (Covers and Panels)
Do not use abrasive, paper or rough products. These could damage the product.
NOTE: Back Cover should only
be removed by a qualified technician.
In order to get an efficient
performance of your refrigerator, clean the back cover of it at least twice a year.
REPLACING REFRIGERATOR LIGHTS
NOTE: The interior lighting for refrigerator uses LED lighting.
DO NOT try to change any LED module. LED lighting should only be replaced by a qualified service technician.
REPLACING FREEZER LIGHTS
ELECTRICAL SHOCK HAZARD
Before replacing a
NOTE: Moving the control to the OFF position does not remove power to the light circuit.
1.Unplug refrigerator power cord form outlet.
2.Use a screwdriver to remove the cover screw. (Save the cover screw)
3.Using a flat instrument, gently pry the lamp cover loose in the front as shown. Rotate downward to remove the rear tabs.
4.Make sure the bulb is cool to the touch. Turn the
bulb counterclockwise to remove.
5.Replace with a new
6.Insert tabs on back of cover into slots in freezer ceiling. Push cover up to snap front into place.
7.Use a screwdriver to assemble the cover screw.
CAUTION
DO NOT place fingers inside of cover. Lamp may be hot.
21
