CARING FOR YOUR MICROWAVE OVEN
CHARCOAL FILTER | COOKTOP/NIGHT LIGHT | ||||
REPLACEMENT | REPLACEMENT | ||||
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
To avoid risk of personal injury or property damage, do not operate oven hood without filters in place.
If your microwave hood combination is installed to recirculate air, the charcoal filter (5230W1A003A) is available by calling the Parts department at your nearest Authorized Service Center. The charcoal filter cannot be cleaned and should be replaced every
1.Unplug microwave oven or disconnect power.
2.Remove the two vent grille mounting screws. (2 middle screws)
To avoid personal injury or property damage, wear gloves when replacing light bulb.
1. Unplug microwave oven or disconnect power.
2.Remove the bulb cover mounting screws.
3.Replace bulb(s) with 20 watt appliance bulb(s).
4.Replace bulb cover, and mounting screws.
5.Plug in microwave oven or reconnect power.
3. Tip the grille forward, then lift out to remove.
4. Remove old filter.
5.Slide a new charcoal filter into place. The filter should rest at the angle shown.
OVEN LIGHT REPLACEMENT
1.Unplug microwave oven or disconnect power.
2.Remove the vent cover mounting screws. (2 middle screws)
3.Tip the cover forward, then lift out to remove.
4. Lift up the bulb holder.
6.Slide the bottom of the grille into place. Push the top until it snaps into place. Replace the mounting screws. Turn the power back on at the main power supply and set the clock.
5.Replace bulb with a 30 or 40 watt appliance bulb.
6.Replace the bulb holder, if damaged.
7.Slide the bottom of the vent cover into place. Push the top until it snaps into place. Replace the mounting screws. Plug in microwave oven or reconnect power.
31