LG Electronics LSWD305ST Preparation For Moving The Oven, Part 2 INSTALLATION REQUIREMENTS, Step

Models: LSWD305ST LSWS305ST

1 13
Download 13 pages 34.74 Kb
Page 7
Image 7
4  PREPARATION FOR MOVING THE OVEN

Part 2 INSTALLATION REQUIREMENTS

4 Step. 1Manual background PREPARATION FOR MOVING THE OVEN

The second step of your installation should be to remove any packing material from the oven before you install the oven.

1.Remove all tape from around the oven.

2.Open the oven door and remove packaging materials and oven racks inside the oven.

3.Door removal is not a requirement for installation of the oven, but is an added convenience. To remove the door, follow the steps below.

ENGLISH

Step. 1

Fully open the door.

Step. 2

Pull the hinge locks down toward (Fig.1) the door frame, to the unlocked position.

Lock

SlotUnlock

Hinge

lock

<Fig.1>

Step. 3

Firmly grasp both sides of the door at the top.

Step. 4

about 5˚

Close door to the door removal

 

position, which is approximately

 

5 degrees. (refer to the Fig.2)

 

Step. 5

 

Lift door up and out until the

 

hinge arm is clear of the slot.

<Fig.2>

 

4.Place the oven on a table or platform even with the cutout opening. (table or platform must support 190lbs [86Kg] for a single built-in oven, 325lbs [147Kg] for a double built-in oven.

5.Remove the metal bottom trim from the oven. It will be installed at the end of the installation process. The trim is wrapped separately and taped to the top of the unit.

Manual background CAUTION

Make sure the cabinets and wall coverings around the oven can withstand the temperature (up to

194˚F[90˚C]) generated by the oven.

- Discoloration, delamination or melting may occur.

IMPORTANT NOTE

Do not lift the door by the handle.

The oven door is very heavy. Be sure you have a firm grip before lifting the oven door off the hinges.

Use caution when lifting. It is recommended that two people lift and position the oven into the cabinet opening. Failure to follow this instruction can result in back or other injury. Wear gloves to protect hands from any sharp edges.

Do not lay the oven door on its handle. This may cause dents or scratches.

Manual background CAUTION

• DO NOT remove spacers on the side walls of the built-in oven.

-These spacers center the oven in the space provided. The oven must be centered to prevent excess heat buildup that may result in heat damage or fire.

Spacer

- 7 -

Page 7
Image 7
LG Electronics LSWD305ST Preparation For Moving The Oven, Part 2 INSTALLATION REQUIREMENTS, Important Note, English, Step