Part 3 ELECTRICAL CONNECTIONS
2 
ELECTRICAL CONNECTION
The fourth step of your installation should be to prepare the electrical connection as follows:
1.Turn off the circuit breaker or remove fuses to the oven branch circuit.
2.With the oven positioned directly in front of the cabinet opening, connect the flexible conduit to the electrical junction box as shown below. Position the conduit in such a manner that it will lie on top of the oven in a natural loop when the oven is installed.
5” Min
Junction Box
Location
22” Min for single wall oven 42” Min for double wall oven
Junction Box must be recessed and conduit connector must be used at Junction Box.
ENGLISH
3.If local codes permit connection of the frame grounding conductor to the neutral(white) wire, follow the instruction of
If used in mobile homes or new construction, or recreational vehicle, or local codes do not permit connection of the frame grounding conductor to the neutral(white) wire, follow the instruction of
IMPORTANT NOTE
•The wall ovens must be hard wired (direct wired) into an approved junction box. A plug and receptacle is not permitted on these products.
•DO NOT shorten the flexible conduit. The conduit connector must be securely attached to the junction box and the flexible conduit must be securely attached to the conduit connector. If the flexible conduit will not fit within the connector, do not install the oven until a connector of the proper size is obtained.
NOTE TO ELECTRICIAN
The power leads supplied with the appliance are UL, CSA recognized for connection to larger gauge household wiring. The insulation of these leads is rated at temperatures much higher than the temperature rating of household wiring. The current carrying capacity of the conductor is governed by the wire gauge and the temperature rating of the insulation around the wire.
- 9 -
