Part 4 Install the Oven

Hinge arm

Bottom edge of slot

Indentation

1 CABINET INSTALLATION

The fifth step of your installation should be to install the oven into the cabinet as follows:

1.Sliding the oven into the opening.

a.Loop (do not tie) a 36” (91cm) string around the conduit before the oven is slid into place.This will keep the conduit from falling behind the oven.

b.Lift oven into cabinet cutout using the oven opening as a grip. Carefully push against the oven front frame. Do not push against outside edges.

c.As you slide the oven back, pull the string so that the conduit will lie on the top of the oven in a natural loop.

d.When you are sure the conduit is out of the way, slide the oven 3/4 way back into the opening. Remove the string by pulling on one end of the loop.

ENGLISH

CAUTION

• DO NOT block the oven air exhaust located at the bottom of the oven.

-Blocking the exhaust may cause cabinet damage and product malfunction.

WARNING

• Mounting screws must be used.

-Failure to do so can result in the oven falling out of the cabinet causing serious injury.

2.Securing the oven.

a.Using the mounting holes on the oven side trim as a guide, drill pilot holes for screws provided (For securing the double wall oven, use a minimum of 4 screws, one on each side in both the upper and lower ovens. For securing the single wall oven, use a minimum of 2 screws, one on each side.)

b.Secure the oven to cabinet with screws provided. If the cabinet is particle board, you must use 3/4” particle board screws. These may be purchased at any hardware store.

3.Installing the metal bottom trim.

a.Place the metal bottom trim centered over the pre drilled mounting holes on the lower base.

b.Using 3 screws provided, secure the bottom trim to the bottom edge of the cabinet.

4.Reinstalling the oven door.

Mounting

Hole

Locations

Mounting

Hole

Locations

Trim Screws	Side
	Trim

Side

Trim

Metal

bottom trim

Lower base

Step. 1

Firmly grasp both sides of the door at the top.

Step. 2

With the door at the same angle as the removal position, seat the

indentation of the hinge arm into the bottom edge of the

hinge slot. The notch in the hinge

arm must be fully seated into the bottom of the slot.

Step. 3

Fully open the door. If the door will not fully open, the indentation is not seated correctly in the bottom edge of the slot.

Step. 4	Hinge arm
Step. 4
Push the hinge locks up	Hinge lock
against the front frame of the
oven cavity to the locked
position.

Step. 5

Close the oven door.

- 11 -

LSWD305ST, LSWS305ST specifications

LG Electronics has consistently been a leader in the home appliance sector, and their latest offerings, the LSWS305ST and LSWD305ST, only strengthen that reputation. These two models represent the pinnacle of innovation in laundry technology, designed to meet the demands of modern households while ensuring efficiency, durability, and enhanced user experiences.

One of the standout features of the LG LSWS305ST and LSWD305ST is their advanced Smart Inverter Technology. This technology intelligently adjusts the energy consumption based on the load size and fabric type, optimizing performance while minimizing energy usage. This not only results in significant energy savings but also leads to a lower environmental impact.

Additionally, both models come equipped with LG's TurboWash 3D technology. This feature allows for a powerful yet gentle washing experience, ensuring that clothes come out clean without the wear and tear often associated with traditional washing methods. The TurboWash system harnesses high-pressure nozzles that spray water and detergent directly onto fabrics, resulting in shorter wash cycles while maintaining exceptional cleaning performance.

The LSWS305ST and LSWD305ST also feature a sleek and modern design that fits seamlessly into any laundry room. Their large capacity drums can handle even the most demanding laundry loads, while the stainless steel finish not only adds a contemporary aesthetic but also provides durability and resistance to rust.

In terms of user convenience, both models are equipped with a user-friendly interface and intuitive controls. The direct drive motor technology minimizes noise and vibration, allowing for quieter operation during wash cycles. Additionally, the SmartThinQ app integration allows users to control and monitor their washer and dryer remotely, offering an unprecedented level of convenience.

Safety and reliability are crucial in any appliance, and LG has taken this to heart with the LSWS305ST and LSWD305ST. With features like child lock and various sensing technologies, users can enjoy peace of mind knowing their appliances are safe and operate efficiently.

In summary, the LG Electronics LSWS305ST and LSWD305ST are remarkable laundry appliances that combine cutting-edge technologies like Smart Inverter and TurboWash, with a user-centric design. These models address the needs of modern consumers by providing efficient, effective, and eco-friendly laundry solutions that cater to families of all sizes. With LG’s commitment to quality and innovation, these washing machines stand as a testament to the brand’s dedication to enhancing everyday life through technology.

LG Electronics LSWD305ST, LSWS305ST Part 4 Install the Oven, Cabinet Installation

Models: LSWD305ST LSWS305ST