Configuration Options via Command Line (Cont.)

View System Information

1.Log in to the OAT100R as described on the previous page.

2.At the Command > prompt, type info and press Enter.

The System Information display identifies important information about the OAT100R, including the unit serial number, software version, hardware ID (firmware version), Control Port MAC and IP addresses, and output configuration, for example:

OAT100R

CodePlus Off Air Transcoder System

Copyright (c) 2010-2012 LG Electronics U.S.A, Inc.

Copyright (c) 2010-2012 Zenith Electronics LLC

Location:

Chicago, IL

SN:

201-12301011

Version

2.1

HW id:

12-19

Ctrl MAC:

00:0C:63:3A:FF:EC

Ctrl IP:

10.166.60.92

Program PIDs:

0x30 - 0x6f

Output:

RF

RF config:

Mode 2, 256-QAM-B, RF: 6 MHz, 5.36 MSps

RF channels:

2 3 4 5

Local time:

Tue Jan 8 14:42:02 CDT 2014

Note: If the system is configured for IP output, the Output field will show “IP” and RF fields will not be present. Also, the Location field is only present if the site location has been specified either in the GUI System Setup screen or in the command line interface Setup Menu.

It is recommended that you record this information for future reference. If you find it necessary to call customer service or engineering support, please have this information available.

Monitor the System

This option enables you to view static or dynamic system streaming data. 1. Log in to the OAT100R as described on the previous page.

2. At the Command > prompt, either:

•Type monitor and press Enter to display the current system data (see example on following page).

•To monitor streaming data in real time, type monitor and the number of seconds before the data refreshes. Then, press Enter. For example, to refresh the data every second, type monitor 1 and press Enter.

When you are finished monitoring streaming data, press Enter to stop the system monitor and return to the Command > prompt.

40

206-4218