Configuration Options via Command Line (Cont.)

Change Tuner

This command enables you to switch to the Tuner Menu for another tuner.

1.At the Tuner Command > prompt, type tuner and press Enter.

2.At the Enter Tuner number [#]> prompt, type the number of the OAT100R X-Port connected to the tuner for which you wish to view/modify configuration. Then, press Enter.

The system will identify the (newly) current tuner and then display a command prompt, for example:

Current Tuner: Tuner-3

Tuner-3 Command >

View Tuner Information

At the Tuner Command > prompt, type info and press Enter to display tuner status and configuration data, for example:

Tuner-1 Info

 

=============

On

Power:

Status:

Streaming

Channel:

7

SNR:

32.9

FEC errors:

0

Signal lock:

Yes

Bitrate:

19.4

Output:

7

Program selection:

Program 1: 1

Program 2: 2

Program 3: 3

Program 4: NC

Program 5: NC

Program 6: NC

Program 7: NC

Program 8: NC

Under standard operating conditions a powered tuner should be streaming (see also note on following page). In addition, the tuner should be locked to the antenna signal; the signal-to-noise ratio should be greater than 18; the number of FEC errors should equal “0” (zero); and the input bitrates should equal 19.4 Mbps. If a tuner does not appear to be operating normally, refer to “Receiver Reception” troubleshooting information on page 70.

206-4218

43