Configuration Options via Command Line (Cont.)

Example: Output IP Configuration Menu

----------------------------

IP Output Configuration Menu

----------------------------

display

Display output IP configuration

set

Configure output IP channel

fill

Fill IP configuration with autoincrement IP

ttl

Set the multicast TTL *

apply

Apply the new IP configuration

exit

Return to the Setup Menu

IP Output Command >

Display Output IP Configuration

1.At the IP Output Command > prompt, type display and press Enter to view the current output configuration, for example:

N

IP Address

Port

---------------- ----

1-1

227.0.0.0

1234

2-1

227.0.0.2

1234

3-1

227.0.0.4

1234

4-1

227.0.0.6

1234

5-1

227.0.0.8

1234

6-1

227.0.0.10

1234

7-1

227.0.0.11

1234

8-1

227.0.0.12

1234

TTL: 1

Note: The multicast TTL is displayed only if the OAT100R software is version 2.0 or later.

2.At the IP Output Command > prompt, type exit and press Enter to return to the Setup Menu when you are finished reviewing the display.

Manually Configure Output IP Channels

This option enables you to specify the multicast IP address and port number for each program. Each program must be assigned a unique IPv4 multicast address. See “Channel Assignments for IP Output” on page 9, and/or check with your service representative, if necessary.

Note: If you wish to set a base multicast IP address and have the system auto-increment the remaining program data, use the “fill” option described below.

1. At the IP Output Command > prompt, type set and press Enter.

(Continued on next page)

*Available only with OAT100R version 2.0 or later software.

206-4218

57