LG Electronics QHW 15, QHW 30, QHW 6 manual Error Codes, Zero/Enter

QHW digital weighing scales user’s guide

SECTION 11 ERROR CODES

During the initial power-on testing or during operation it is possible the scale may show an error message. The meaning of the error messages is described below.

If an error message is shown repeat the procedure that caused the message, turning the balance on, calibration or other functions. If the error message still is shown then contact your dealer for further support.

ERROR CODE	DESCRIPTION				POSSIBLE CAUSES
Err 4	Initial Zero is greater than				Weight on the pan when turning the
	allowed	(4% of	maximum		scale on.
	capacity)	when	power	is	Excessive weight on the pan when
	turned on or when the				zeroing the scale.
	ZERO/ENTER		key	is	Improper calibration of the scale.
	pressed,				Damaged load cell.
					Damaged Electronics.
Err 5	Keyboard Error.				Improper operation of the scale.
Err 6	A/D count is not correct				Platform not installed.
	when turning the scale on.				Load cell damaged.
					Electronics damaged.

To view the A/D count press the ZERO/ENTER key and the % key at the same time while the scale is performing the initial check at power-on. Press ZERO/ENTER to return to normal.

- 14 -