Cloning Procedures (Cont.)

Learn Setup from Master STB

1.Ensure the Master STB is set up completely and in Pass-through Mode (i.e., the STB setup menus should be displayed on the screen when you press MENU on the Installer Remote).

2.Insert the USB memory device into either of the USB ports on the Master STB.

3.Press MENU on the Installer Remote to display the STB setup menus. Use the arrow navigation keys to select/highlight the Option menu icon, and then press the number “7” key a total of seven times to display the USB Download Menu.

4.To gain access to the “Learn From STB” options in the USB Download Menu, key in the following number sequence on the Installer Remote:

9-8-7-6.

5.Use the Up/Down arrow keys to select Learn From STB (TLX), and then press OK.

6.In the Learn From STB (TLX) window, to differentiate this TLX file from others, you can use the Up/Down arrow keys to change the last five digits of the filename. Press OK when you are ready to initiate Learning.

Learning status will be shown on a progress bar in a new window. Do NOT remove the USB device until Learning is complete. When the Learning process is complete, the USB Download menu will reappear on the screen.

7.When Learning is done, press on the Installer Remote to exit the USB Download Menu, and remove the USB memory device from the Master STB.

Teach Master STB Setup to Target STB

1.Turn ON the Target STB/display panel.

2.The next step depends on whether the EZ-Manager Wizard appears on the screen when you turn ON the STB/display:

•If the wizard is displayed, the STB is in the required factory default state. To continue with this procedure (see also note below), exit the wizard, and then continue with step 3.

•If the wizard is not displayed, restore the STB to a factory default condition before continuing with this procedure. See Reference section, “Restoring Factory Defaults on the STB(s),” as necessary, for further information.

Note: If desired, you can complete the Teaching process via the EZ- Manager Wizard (see “USB Configuration” on page 22) or using the LG Smart Install utility (see “LG Smart Install Utility” on pages 23 to 24).

USB Download Menu

Upgrade STB Software

Upgrade PTC Software

Diagnostics

Teach To STB (TLL)

Teach To STB (TLX)

Learn From STB (TLL)

Learn From STB (TLX)

Previous

OK

Note: The Diagnostics option in this menu is for service use only.

Learn From STB (TLX)

Select the file name and press OK to start

V

 

STB-2000-UA00003.TLX

 

V

 

Previous

OK

Learn From STB

UPDATING...

25%

Do not unplug!

(Continued on next page)

206-4256

41