TROUBLESHOOTING GUIDE
ENGLISH
Problem | Possible Cause |
| Solution |
| • Water supply is not adequate | Check another tap in the house. | |
| in area. |
|
|
| • Water supply taps are not | Fully open tap. | |
| completely open. |
|
|
| • Water inlet hose is bent. | Straighten hose. | |
| • The filter of the inlet hose | Check the filter of the inlet hose. | |
| clogged. |
|
|
| • Drain hose is bent | Clean and straighten the drain hose. | |
| or clogged. |
|
|
| • The drain filter is clogged. | Clean the drain filter. | |
| • Load is too small. | Add 1 or 2 similar items to help | |
| • Load is out of balance. | balance the load. | |
| • The appliance has an | Rearrange load to allow proper | |
| imbalance detection and | spinning. | |
| correction system. If individual |
|
|
| heavy articles are loaded (bath |
|
|
| mat, bath robe, etc.) and the |
|
|
| imbalance is too great, after |
|
|
| several attempts to restart the |
|
|
| spin cycle the machine will |
|
|
| stop and the error code will be |
|
|
| displayed. |
|
|
| • Is the door opened or not | Close the door completely. | |
| completely closed? | ✽ If | is not released, call for service. |
|
| Unplug the power plug and call for service. | |
| • The water overfills due to the | Close the water tap. | |
| faulty water valve. | Unplug the power plug. | |
|
| Call for service. | |
•The water level sensor malfunction.
•Overload in motor.
•Overload in motor.
• The washer experienced a | Restart the cycle. |
power failure. |
|
2 1