2.0UNPACKING AND INSTALLATION
2.1Unpacking and Preliminary Inspection
1.Inspect the shipping crate(s) for damage or signs of mishandling before unpacking the unit.
2.Remove any securing bands and cardboard packing and inspect the unit for any obvious shipping damages.
3.If any damage as a result of shipping is observed, immediately file a claim with the shipping agency and forward a copy to your local Liebert sales representative.
2.2Handling Considerations
Larger units are bolted to a shipping pallet to facilitate handling by forklift or pallet jack. Check the size and weight. Refer to the cabinet data furnished with the unit. Typical size and weights are referred to in Table 1.
2.3Storage
The unit should be stored in a clean, dry environment. Storage temperature range is
2.4Location Considerations
The unit is provided in an industrial use enclosure that is
Audible
Service
2.4.1Equipment Performance
For maximum system performance, the unit must be located as close to the protected circuit as practical to minimize interconnecting wiring length.
For optimum transient surge protection, coordinated surge suppression should be applied at the service entrance and all other electrical connections to the building (telephone, CATV, etc.), at known surge generating loads within the building (large motors, arc welders, switched capacitors, etc.), as well as at sensitive electronic loads (such as computers, electronic appliances, solid state motor drives, etc.). For interconnected electronic loads (such as by way of data cabling), transient surge suppression should also be applied to the interconnecting wiring (data cables).
2.5Door Closing Adjustments
If the surface on which the enclosure is mounted is not flat, the door may not open and close prop- erly. Also, if heavy equipment is mounted on a large door, the door may sag slightly. If the top of the door strikes the lip that extends around the body opening, place metal shims behind the mounting foot that is located at the bottom of the enclosure and closest to the door hinge. Place the shims between the mounting foot and the wall or mounting surface. Be sure all mounting screws are tightened securely
2Unpacking and Installation