Jet Tools 18QT-3 Adjustments, Adjusting 90 Degree Table Stop, Loosen the lock knobs/lock handle G

Adjustments

Table Tilt

Referring to Figure 14:

1. Disconnect machine from power source.

2. Loosen the lock knob(s)/lock handle (G).

3. Tilt table up to 45 degrees to the right, or up to 10 degrees to the left.

4. Tighten the lock knob(s)/lock handle.

Note: Table stop bolt (F, Fig. 14) must be removed
to tilt table to the left.	Figure 14

Adjusting 90 Degree Table Stop

Before adjusting the 90º table stop, the blade tension must be properly adjusted (described in the Blade Tension section).

To adjust the 90º table stop:

1.Loosen lock knob(s)/lock handle (C, Fig. 15) and tilt the table until it rests against table stop bolt (B, Fig. 15); then re-tighten the lock knob(s)/handle.

2.Use a square (E, Fig. 16) placed on the table and against the blade to see if the table is 90 degrees to the blade.

3.If an adjustment is necessary, loosen the lock knob(s)/handle (C, Fig. 15). Tilt the table until it is square to the blade; then re-tighten the lock knobs.

4.Loosen lock nut (A, Fig. 15) and turn table stop bolt (B, Fig. 15) until it contacts the table. Tighten the nut (A, Fig. 15) to hold table stop in place. When tightening the nut hold the table stop bolt in place with a wrench to prevent movement.

5.If necessary, adjust the pointer (D, Fig. 15) to zero.

14

Figure 15

Figure 16