2.4Mounting the XDA on the Interior of the Rear Cabinet Door
2.4.1Prepare to Install the Unit
NOTE
For mounting inside the cabinet, the mounting angles must first be reversed, as described in Steps 1 through 4 below.
1. Remove the screws on the | Wider side of mounting | |||
| sides of the XDA that | |||
| angle with round holes | |||
| secure the mounting angles | |||
| fits against XDA | |||
| to the unit. | |||
|
|
|
| |
2. | Remove the mounting |
|
|
|
| angles. |
|
|
|
3. Position the angles so their |
|
|
| |
| mounting surfaces are near |
|
|
|
| the front of the XDA. (This |
|
|
|
| is the air discharge side, | Slotted | ||
| which has the Liebert logo | holes must | ||
| and longer, horizontal slots | face mounting | ||
|
| surface | ||
| over the fans.) To reverse |
| ||
|
|
|
| |
| the position of the mounting |
|
|
|
| angles properly, rotate |
|
|
|
| them vertically so that the |
| Mounting |
|
| tops of the angles are at the |
| angles |
|
| bottom of the XDA and the |
| attached |
|
| for interior |
| ||
| bottoms are at the top. |
| ||
| mounting |
| ||
4. Reattach the angles using |
| |||
|
|
| ||
| the screws removed in |
|
|
|
| Step 1 above. |
|
|
|
5. | Determine the desired |
|
|
|
| mounting position on the |
|
|
|
| door. Place the bracket on |
|
|
|
| the top of the door with the |
|
|
|
|
|
|
| |
| tabs on the outside. (The mounting bracket will be used to deter- | |||
| mine the correct holes for screws attaching the XDA to the cabinet | |||
| door.) |
|
|
|
6.Locate the desired mounting holes on the door for the unit.
7.From the outside of the door, place screws through the bracket, then through the door. Place nuts on the screws and tighten them. The nuts should now be visible on the inside surface of the door.
5
