Control
WARNING
Risk of injury due to the door dropping out!
If the bearing parts are not screwed into place firmly enough, the door may drop out. This may lead to severe injuries. What is more, the door may not close and therefore the appliance may fail to cool properly.
u Screw the turn hinges firmly into place with 4 Nm. u Check all of the screws and retighten if necessary.
4.4 Insertion into a row of kitchen units
(1) | Stack cabinet | (3) | Fig. 9 |
Kitchen cabinet | |||
(2) | Appliance | (4) | Wall |
The appliance can be inserted into a row of kitchen units. To match the appliance Fig. 9 (2) to the height of the row of units, a suitable stack cabinet Fig. 9 (1) can be fitted above the appli- ance.
When inserting the appliance into a row of kitchen units (max. depth 580 mm), the appliance can be installed directly next to the kitchen unit Fig. 9 (3). The appliance door projects relative to the front of the kitchen unit by 34 mm at the side and by 50 mm in the middle of the appliance. It can be opened and closed perfectly as a result.
Important for the ventilation:
-At the back of the stack cabinet there has to be a ventilation duct of at least 50 mm depth throughout the width of the stack cabinet.
-The ventilation space under the ceiling has to be at least 300 cm2.
-The larger the ventilation space, the more
If the appliance is installed with the hinges next to a wall Fig. 9 (4), the distance between appliance and wall has to be at least 40 mm. This corresponds to the projection of the handle when the door is open.
4.5 Disposing of packaging
WARNING
Danger of suffocation due to packing material and plastic film! u Do not allow children to play with packing material.
The packaging is made of recyclable materials:
-corrugated board/cardboard
-expanded polystyrene parts
-polythene bags and sheets
-polypropylene straps
-nailed wooden frame with polyethylene panel*
uTake the packaging material to an official collecting point.
4.6 Connecting the appliance
NOTICE
Risk of damage to the electronic control system!
u Do not use
WARNING
Fire and overheating hazard!
u Do not use extension cables or multiple socket outlets.
The type of current (alternating current) and voltage at the installation site have to conform with the data on the type plate (see Appliance at a glance).
Connect the appliance only with a properly installed socket outlet with earthing contact. The socket outlet must be fused with 10 A or higher.
It must be easily accessible so that the appliance can be quickly disconnected from the supply in an emer- gency. It must be outside the area of the rear of the appliance.
u Check the electrical connection. u Plug in the power plug.
4.7 Switching on the appliance
Put the appliance into operation about 2 hours before first loading food to be frozen.
Do not load food to be frozen before the temperature display reads
u Press On/Off button Fig. 3 (7).
w The interior light is on when the door is open.
5 Control
5.1Brightness of the temperature display
You can adjust the brightness of the temperature display to the light conditions of the room in which the appliance is installed.
5.1.1 Adjusting the brightness
The brightness is adjustable between h0 (no illumination) and h5 (maximum luminosity).
u To activate the setting mode: press the SuperFrost button Fig. 3 (8) for about 5 s.
w The display indicates c.
w The menu symbol Fig. 3 (3) shines.
u Using the Up setting button Fig. 3 (1) or Down setting button, Fig. 3 (2), select h.
7
