Controls and displays
3 Controls and displays
3.1 Operating and control elements
Fig. 3 | (6) | Menu symbol | |
(1) | On/Off button | ||
(2) | Setting button | (7) | Alarm symbol |
(3) | Temperature display | (8) | Brightness symbol |
(4) | SuperFrost button | (9) | Child lock symbol |
(5) | SuperFrost symbol |
|
|
3.2 Temperature display
The following are displayed in normal operation:
-the set freezing temperature
The temperature display flashes:
-the temperature setting is being changed
-after
-the temperature has risen several degrees
4 Putting into operation
4.1 Transporting the appliance
CAUTION
Risk of injury and danger of damage as a result of incorrect transport!
u Transport the appliance in a packed condition. u Transport the appliance upright.
u Do not transport the appliance without assistance.
4.2 Installing the appliance
WARNING
Fire hazard due to dampness!
If live parts or the mains lead become damp this may cause short circuits.
u The appliance is designed for use in enclosed areas. Do not operate the appliance outdoors or in areas where it is exposed to splash water or damp conditions.
WARNING
Risk of fire due to short circuit!
If the mains cable/connector of the appliance or of another appliance touch the rear of the appliance, the mains cable/ connector may be damaged by the appliance vibrations, leading to a short circuit.
u Stand the appliance so that it is not touched by connectors or main cables.
u Do not plug the appliance or any others into sockets located near the rear of the appliance.
WARNING
Fire hazard due to refrigerant!
The refrigerant R 600a is environmentally friendly but flam- mable. Escaping refrigerant may ignite.
u Do not damage the piping of the refrigeration circuit.
WARNING
Fire hazard and danger of damage!
u Do not place appliances emitting heat e.g. microwaves, toasters etc. on the appliance!
WARNING
Blocked ventilation openings pose a risk of fire and damage! u Always keep the ventilation openings clear. Always ensure
that the appliance is properly ventilated!
q In the event that the appliance is damaged, contact the supplier immediately before connecting to the mains.
q The floor at the site must be flat and level.
q Do not install the appliance in a location where it is exposed to direct radiation of the sun, next to a cooker, heater and similar.
q The ideal installation site is a dry, well ventilated room.
q Always stand the appliance with its back directly to the wall. q The appliance may be moved only when it is empty.*
q Do not install the appliance without assistance.
q Standard EN 378 specifies that the room in which you install your appliance must have a volume of 1 m2 per 8 g of R 600a refrigerant used in the appliance. If the room in which the appliance is installed is too small, a flammable
u Detach the connecting cable from the rear of the appliance, removing the cable holder at the same time because other- wise there will be vibratory noise!
u Remove all transit supports.
u Dispose of packaging material (see 4.5) . u Align the appliance so that it
stands firmly and on a level by applying the accompanying spanner to the adjustable- height feet (A) and using a spirit level.
Note
u Clean the appliance (see 6.2) .
If the appliance is installed in a very damp environment, condensate may form on the outside of the appliance.
u Always see to good ventilation at the installation site.
4.3 Changing over the door hinge*
You can change over the door hinges if necessary. Make sure that the following tools are at hand:
q Supplied
4
