Liebherr 7081 203-00 manual Malfunctions, Shutting your appliance down, Changing over door hinges

Malfunctions

You may be able to rectify the following faults by checking the possible causes yourself:

• Appliance does not function:

– Is the appliance switched on?

– Is the plug correctly fitted in the mains socket?

– Is the socket fuse intact?

• Loud running noise:

– Is the appliance set up firmly on the floor?

– Does the appliance cause nearby items of furniture or objects to vibrate? Ensure that the appliance is stable and that all parts at the back can vibrate freely.Please note that noises caused by the refrigerant circuit cannot be avoided.

• The temperature is not low enough:

– Is the temperature setting correct (see „Setting the temperature“)?

– Does the separately installed thermometer show the correct read- ing?

– Is the ventilation system working properly?

– Is the appliance set up too close to a heat source? If none of the above causes apply

and you cannot rectify the fault your-

self, contact the nearest customer

service department stating the type of appliance 1, service number

2and appliance number 3as in- dicated on the type plate. The type plate is located in the refrigerator compartment on the left-hand side.

Shutting your appliance down

If your appliance is to be shut down for any length of time, switch it off and disconnect the plug or remove the fuse. Clean the appliance and leave the door open in order to prevent unpleasant smells.

The appliance complies with the relevant safety regulations and EC directives 2004/108/EC and 2006/95/EC.

All types and models are subject to continuous improvement and the manufacturer therefore reserves the right to make modifica­ tions to the shape, equipment and technology.

Changing over door hinges

1.

Remove screw from lower hinge bracket.

2.

Lift door 1, tilt to the right 2 and remove 3.

GB

3.

Transfer handle to the opposite side.

4.

Transfer pin to the opposite side of the door.

5.

Transfer upper hinge components to the opposite side.

6.

Transfer lower hinge bracket to the opposite side.

7.

Locate door on upper pin.

8.

Tilt door inwards from the left 1. Se- cure hinge pin with screw 2.

9