Liebherr 7081 203-00 Climate rating, Setting up, Dimensions Connecting to the mains, Fan switch

Models: 7081 203-00

1 5
Download 5 pages 61.13 Kb
Page 3
Image 3
Climate rating

Climate rating

The appliance is set to operate within specific ambient temperature limitsaccordingtoitsclimaterating.Thesetemperaturelimitsshould not be exceeded. The correct climate rating for your appliance is indicated on the type plate.

Climate rating

Ambient temperature

SN

+10°C to +32°C

N

+16°C to +32°C

ST

+16°C to +38°C

T

+16°C to +43°C

The appliance complies with the relevant safety regulations and EC directives 2004/108/EC and 2006/95/EC.

Setting up

Avoid positioning the appliance in direct sunlight or near cookers, radiators and similar sources of heat.

The floor on which the appliance stands should be horizontal and level.Compensate for uneven floors with the adjustable feet.

Always ensure that there is good ventilation and that the outward flowing air is able to escape.

Standard EN 378 specifies that the room in which you install your appliance must have a volume of 1 m3 per 8 g of R 600a refrigerant used in the appliance, so as to avoid the formation of inflammable gas/air mixtures in the room where the appliance is located in the event of a leak in the refrigerant circuit.The quantity of refrigerant used in your appliance is indicated on the type plate on the inside of the appliance.

Do not connect the appliance to the supply with other equipment using an extension cable - risk of overheating.

Always install the appliance directly against the wall.

Dimensions

Connecting to the mains

Power supply (a.c.) and voltage at the operating point must comply with the details on the type plate. The socket must be fused with a 10 A fuse or higher, it must be away from the rear of the appliance and must be easily accessible.

Connect the appliance with a properly earthed fused plug and socket only.

GB

Operating and control elements

1Temperature display

2Temperature setting buttons

3Audible warning on/off button

4Fan on/off button

5Child-proof lock

6On/off button

Switching the appliance on and off

You are recommended to clean the appliance before switching­ it on for the first time (see Cleaning). Connect the appliance to the mains - the appliance is switched on.

To switch the appliance on: Press the ON / OFF button until the Display lights up.

To switch the appliance off: Keep the ON / OFF button pressed for 3 sec. so that the temperature display goes out.

Setting the temperature

To reduce the temperature: Press the DOWN button;

To increase the temperature: Press the UP button.

-While you are entering the temperature, the set temperature will flash on the display.

-You can change the settings in increments of 1°C briefly pressing the button again.

-The electronic controls will switch over automatically about 5 seconds after the last time you pressed the button, and the actual temperature will be displayed.

If F 1 appears in the display, the appliance has a fault. Consult your nearest customer service point.

Fan switch

Thereby a climate which corresponds to that of a wine cellar is achieved inside the wine cooler. Corks are prevented from drying out due to an increased level of humidity.

To switch on: Press the Ventilation button.The indicator lamp in the switch will light up.

To switch off: Press the Ventilation button.The indicator lamp in the switch goes dark.

Storing wine

If you are storing wine for long periods of time, it should be stored at a temperature of between 10°C and 14°C.

This is the temperature wine cellars are kept at, and it is just right to allow wine to mature properly.

The following drinking temperatures are recommended for the various types of wine.

Red wines: +14°C to +18°C

Rosé wines: +10°C to +12°C

White wines: +8°C to +12°C

Sparkling wines, Prosecco +7°C to +9°C

Champagne +5°C to +7°C

Caution!

The maximum load capacity of the wood racks is 80 kg.

7

Page 3
Image 3
Liebherr 7081 203-00 manual Climate rating, Setting up, Dimensions Connecting to the mains, Operating and control elements