Audible warning signal | Air exchange with activated charcoal filter | |
The audible warning signal helps to protect your wines against | The way in which wines con- | |
excessive temperature fluctuations. | tinue to mature depends on the | |
- It sounds when the door has been left open for longer than | ambientconditions.Thequality | |
of the air is therefore decisive | ||
about 60 seconds.The audible warning device is switched | ||
for preserving the wine. | ||
off by pressing the "Alarm" button. | ||
- It sounds when the interior gets too warm or too cold.The tempera- | We recommend that you re- | |
ture display will also flash.The audible warning device is switched | place the filter once a year. | |
off by pressing the "Alarm" button. The temperature display will | Filters can be obtained from | |
continue to flash until the cause of the alarm has been rectified. | your dealer. |
Additional functions
In
Activating set-up mode:
• Press Ventilation button for approx. 5 secs. - The display shows c for
• Select the required function by pressing the Up/Down button: c =
• Now select/acknowledge the function by pressing the Ventilation button briefly:
Changing the filter:
Take the filter by the handle. Turn it 90° to the left or right and remove.
Inserting the filter:
Insert with the handle in a verti- calposition.Turnit90°totheleft or right until it clicks into place.
>For c =
c1 =
c0 =
When the symbol is lit, the
>For h = brightness, press the Up/Down button to select
h1 = minimum to
h5 = maximum brightness and acknowledge with the Ventilation button.
Exiting set-up mode:
Exit the
Interior light
Bulb data: 15 W (never use a bulb rated at more than 15 W). The volt- age should agree with the details on the type plate.
Socket: E 14.
Replacing the bulb:
Pull out the mains plug or re- move/unscrew the fuse.
Change the bulb behind the oper- ating panel.
Safety lock
Locking the appliance:
• Insert the key as shown by arrow 1.
• Turn the key 90°.
To unlock the appliance, the same procedure must be re- peated in the same order.
Defrosting
The appliance defrosts automatically.
Cleaning
Before cleaning always switch off the appliance. Pull out the mains plug or remove/unscrew the fuse.
•Clean the inside, equipment and outer walls with lukewarm water and a little detergent. Do not use abrasive or acid cleaners or chemical solvents.
Do not use steam cleaners because of the
risk of injury and damage.
•Ensure that no cleaning water penetrates into the electrical com- ponents or ventilation grille.
•The dust should be removed from the refrigeration unit and heat exchanger - metal grid at the back of the appliance - once a year.
•Do not damage or remove the type plate on the inside of the ap- pliance. It is very important for servicing purposes.
8