Setup mode
The following functions can be activated in setup mode: 
= Child lock
= Confirm water filter change
= Ice maker vacation state
= Water quantity for ice cube tray
= Set BioFresh temperature
= Display brightness
= Door gasket heating control 
=Confirm dust filter cleaning
Activating setup mode:
• Touch the SuperFrost icon for five seconds. 
-The SuperFrost LED 
comes on for 5 seconds,
-after 5 seconds 
will flash in the display.
The appliance is in setup mode now.
You can select the setup mode functions by touching the freezer compartment temperature setting icons.
Note: In setup mode the display will flash continuously.
= Confirm water filter change
Afterthewaterfilterhasbeenchanged,the drop symbol on the display must be reset.
Resetting the drop symbol
• Activate setup mode by touching the SuperFrost icon for 5 seconds.
•Touch the freezer compartment Down icon until 
appears in the display.
• Touch the SuperFrost icon. - The display reads
•Touch the SuperFrost icon again. - The display reads
•The drop symbol disappears.
• Exit setup mode by touching 
the freezer compartment On/Off icon. 
= Ice maker vacation state
See section entitled "Ice maker".
Exiting setup mode:
• Touch the freezer compartment On/Off icon
The appliance will change back to normal operation.
= Child lock
The child lock is designed to protect the appliance from being switched off accidentally.
Activating the child lock
•Activate setup mode by touching the SuperFrost icon for 5 seconds.
- The display reads
• Touch the SuperFrost icon.
- The display reads
• Touch the SuperFrost icon again.
- The 
LED is lit and the child lock is activated.
• Exit setup mode by touching 
the freezer compartment On/Off icon. 
Deactivating the child lock
•Activate setup mode by touching the SuperFrost icon for 5 seconds.
- The display reads
• Touch the SuperFrost icon.
- The display reads
• Touch the SuperFrost icon again.
- The 
LED goes out. The child lock is deactivated.
• Exit setup mode by touching
the freezer compartment On/Off icon.
= Water quantity for ice cube tray
If the produced ice cubes of the ice maker are too small, the inflow- ing water quantity can be adjusted.
Adjusting the water quantity
•Activate setup mode by touching the SuperFrost icon for 5 sec- onds.
•Touch the freezer compartment Down icon until appears in the display.
•Touch the SuperFrost icon.
-The display reads 
•Touch the freezer compartment Up icon once only so that E 4 appears in the display.
Caution!
Do not increase for more than one step. If the adjusted value is too high, the ice cube tray of the ice maker could overflow.
•Touch the SuperFrost icon again.
•Exit setup mode by touching the 
freezer compartment On/Off icon. 
Check the ice cube size within the next days. If the ice cubes are still too small, follow the steps above again.
18
