Bleeding the ice maker
To ensure that the ice maker works properly, the water supply line must be bled.
• Touch the IceMaker icon | so that the IceMaker LED |
comes on. |
|
•Open the top freezer drawer.
•Press the ON/OFF button on the ice maker housing for approx. 3 seconds. TheLEDabovethebuttonstartsflash- ing.
• Press the button again briefly. The
LED flashes more quickly.
• Closethefreezerdrawerimmediately.
The water supply valve opens for 25 seconds and pumps all the air out of the water supply system.
•Then the ice cube tray of the ice maker must be completely emptied. See the section Activating the ice maker vacation state.
•Finally, clean the ice cube bin.
| Ice cube bin |
Switching the ice maker on | |
• Touch the IceMaker icon | so that the IceMaker LED |
comes on. |
|
After you start the ice maker for the first time, it may take up to 24 hours before the first ice cubes are ready.
The production capacity depends on the temperature inside the freezer compartment. The lower the temperature, the more ice cubes can be produced over a period of time.
The ice cubes fall out of the ice maker into the ice cube bin. When the ice reaches a certain level in the bin, the appliance stops pro- ducing ice automatically.
Switching the ice maker off
If you do not need any ice cubes, the ice maker can be switched off independently of the freezer compartment.
• Touch the IceMaker icon | so that the IceMaker LED |
goes out. |
|
The ice maker can also be |
|
switched on and off using the |
|
ON/OFF button at the ice maker |
|
housing. |
|
Press the button for approxi- |
|
mately 1 second. |
|
GB
Ice maker vacation state
In case of longer vacations, the ice cube tray should be emptied.
By setting the ice maker into the vacation state, the tray will rotate down and no water remains in the tray.
The freezer drawer must be
left open so that the surface
of the tray dries up and no mould
or unpleasant odours can occur.
Activating the ice maker vacation state | |
Be sure the upper freezer drawer is com- |
|
pletely closed and the ice cube bin is |
|
installed correctly. |
|
• Activate setup mode by touching the Su- |
|
perFrost icon for 5 seconds. | Ice cube bin |
|
•Touch the freezer compartment Downicon until appears in the display.
•Touch the SuperFrost icon.
-The display reads
or
depending on whether the ice maker is switched on or off.
• Touch the freezer compartment Down icon. - The display reads
• Touch the SuperFrost icon.
- The digitflashes. The ice cube tray rotates down.
When the interior temperature appears in the display, the tray is in the down position and the ice maker is switched off automatically.
23